User manual AIRLIVE HP-2000E

[. . . ] the top panel of the screen shot shows a HomePlug device connected locally to the host computer. The bottom panel shows four devices connected remotely to the computer running the utility, which includes HP1000E series and HP2000E Series. Figure 3 illustrates the scenario where a HP2000E Series device is connected as a local device to the computer. [. . . ] A user can change the name by either using the rename button or by clicking on the name and editing in-place. Password column by default is blank and `Enter Password' button can be used to enter it. To set the Password of the device (required when creating a private network), first select the device by clicking on its name in the lower panel and then click on the Enter Password button. The selected device name is shown above the password field and the password can be verified by hitting the OK button. The Password field accepts the Device password in any case formats, with or without dashed between them. a confirmation box will appear if the password was entered correctly. If a device was not found, the user will be notified along with the suggestions to resolve common problems. The dialog box allows the user to enter both a device name and the password. A confirmation box will appear if the password was entered correctly and if the device was found in the powerline network. If a device was not found, the user will be notified and suggestions to resolve common problems will be presented. Note: The device must be present on the power line (plugged in) in order for the password to be confirmed and added to the network. The Scan button is used to perform an immediate search of the HomePlug devices connected to the Powerline network. By default, the utility automatically scans every few seconds and updates the display screen. A typical screen after naming and supplying passwords might appear as in Figure 7. The Privacy screen provides the user with an option to maintain security for their logical network and also to select the devices that has to be included in the network. All HomePlug devices are shipped using a default logical network (network name), which is normally "HomePlug". Note: Changing the network name to anything other than HomePlug will show the network type on the main screen as Private. The Set Local Device Only button can be used to change the network name (network password) of the local device. [. . . ] The following remote device information is available from the diagnostics screen: Device Alias Name Device MAC Address Device Password Device Last known rate Device Last Known Network name HomePlug chipset manufacturer name Date device last seen on the network MAC Firmware Version (HP2000E Series Only) The diagnostics information displayed may be saved to a text file for later use, or can be printed for reference for a technical support call. Devices, which are not part of the network anymore, can be deleted using the delete button. A dialog window pops up with a confirmation message if we try to delete a device whose password has been entered. [. . . ]