Detailed instructions for use are in the User's Guide.
[. . . ] Electromagnetic compatibility and Radio spectrum Matters (ERM); Electromagnetic compatibility(EMC) standard for radio equipment and Services; Part 17Specific conditions for wideband data and HIPERLAN equipment Generic standard to demonstrate the compliance of low power Electronic and electrical apparatus with the basic restrictions related to human exposure to electromagnetic field (10MHz 300GHz) -General public Safety for information technology equipment including electrical business equipment Note on the FCC standard This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interferences when the equipment is operating in a commercial area. [. . . ] This warranty shall not be applicable in the event of damage caused by improper use of the product, accidents, faulty handling or manipulation nor any future incompatibility with third party products. When using these modes, please do not select Super A or Super G modes. Please install your network cards first before the AP Screw-in the antenna (clockwise) into the Antenna connector Connect the power and LAN cable to the back Use your wireless card to do a site survey, the default SSID is airlive If you need to change AP's configuration, please follow the procedure below: The AP mode's default IP address is 192. If you need extra configuration of encryption, please refer to the encryption session of the user's manual for further information. The client can search for the SSIDs of APs in the environment using site survey tool. In Advanced Setting >>Operation mode>>WDS bridge Select "WDS Bridge" mode and then press the `APPLY` button. When configured in WDS Bridge Mode, further configure the name and MAC address of its peer WDS devices. Select Setup Wizard; then select Wireless Setting on the left side Choose the Super A mode if and only if you are connecting with another Super A device. 11a mode in Czech and Slovakia countries , please do not use "auto" channel selection. Please choose your frequency channel according to the instruction below: Indoor: Channels 36, 40, 44, 48, 52, 56, 60, 64 Outdoor: Channels 100, 104, 108, 112, 116, 120, 124, 128, 132, 136, 140 The AP is preset to comply with the frequency range of your country. [. . . ] OvisLink Corporation declares that this device is in compliance with the essential requirements and other relevant provisions of directive 1999/5/EC. This equipment may be used in AT, BE, CY, CZ, DK, EE, FI, FR, DE, GR, HU, IE, IT, LV, LT, LU, MT, NL, PL, PT, SK, SI, ES, SE, GB, IS, LI, NO, CH, BG, RO, TR OvisLink Corporation declares that this device is in compliance with the essential requirements and other relevant provisions of directive 1999/5/EC. [. . . ]