User manual APRILIA SCARABEO50I.E DEALER INSTRUCTION

[. . . ] SCARABEO 50 i. e. SCARABEO 50 i. e. DEALER INSTRUCTION SHEET 2 1 1 DEALER INSTRUCTION SHEET ASSEMBLING THE LOCK · Remove the nut (1) from the lock unit (2). · Fit the lock unit to the housing on the street car cover and secure with the nut (1). Scarabeo 50 i. e. Scarabeo 50 i. e. INSTRUCTIONS FOR REMOVING MOTORCYCLE FROM CRATE SAFETY MESSAGES For the sake of safety, before starting the vehicle, carry out a thorough preliminary check. [. . . ] After removing the nailed-on supports and crosspieces from the crate (used for transport purposes), push the motor cycle off the bottom of the crate and position it on the stand. You can now proceed with the operations described below. DANGER Risk of serious injury or death. CAUTION Possible risk of slight injury or damage to motor cycle. IMPORTANT The word "IMPORTANT"is written before any important information on the instruction sheet. aprilia part #8202313 - 01/02 - USA Pag. 1 SCARABEO 50 i. e. SCARABEO 50 i. e. DEALER INSTRUCTION SHEET 4 DEALER INSTRUCTION SHEET 2 1 2 2 1 1 3 INITIAL BATTERY CHARGING · Lift the saddle (1) and remove the tool kit holder (2). · Fit the container into the battery as shown in the drawing (see the battery instructions in the recharge pack). FITTING THE STORAGE BOX 1 BATTERY Battery electrolyte is toxic, caustic and the contact with the skin may cause serious burns, since it contains sulfuric acid. Wear protective clothing, a face shield and/or tight fitting goggles when working around the battery. In case of contact with the skin, flush immediately with plenty of water. In case of contact with the eyes, flush with plenty of water for at least 15 minutes. If the electrolyte is accidentally swallowed, drink large quantities of water or milk, and then milk of magnesia or vegetable oil. The battery gives off noxious and explosive gases; keep it away from cigarettes, flames, sparks and any other source of heat. During the recharging or the use, make sure hat the room is properly ventilated and avoid inhaling the gases released during the recharging. Do not tip the vehicle too much, or tip the battery too much, to avoid electrolyte leaking out. Follow the assembly instructions for the storage box. · Fit the spacer bushes (1) in the carrier housings and the inner street case housings. · Secure the street case to the carrier with the screws TBEI M6X35 (2) and self-locking nuts M6 (3). Screw (2) tightening torque: 7. 37 ftlb (10 Nm). 3 CAUTION The battery liquid is corrosive. When the battery has been removed it must be placed in a safe place out of the reach of children. [. . . ] · Fit the wheel and the mileage counter drive gear (3) positioning the tongue (A) in the hub housing. DANGER Before carrying out any maintenance operation or inspection of the front wheel, if possible hoist the vehicle onto a solid and level surface with suitable equipment. When disassembling and reassembling the front wheel, take extra care not to damage the brake lines, discs or pads. IMPORTANT Make sure the transmission is properly fitted into the wheel hub. 5 · Between the hub and fork, place a washer (4), then secure the wheel pin M 12 (5). Tightening torque 5: 25. 81 ftlb (35 Nm). IMPORTANT IMPORTANT To fit the front wheel, you may require a helper. 4 IMPORTANT Make sure the mileage counter cable is fitted properly, as shown in the figure. Pag. [. . . ]