Detailed instructions for use are in the User's Guide.
[. . . ] - Noale (VE)
3!&%49 7!2. ). '3 The following precautionary warnings are used throughout this manual in order to convey the following messages:
4%#(. )#!, The operations preceded by this symbol must be repeated also on the opposite side of the vehicle. If not expressly indicated otherwise, for the reassembly of the units repeat the disassembly operations in reverse order. The terms "right" and "left" are referred to the rider seated on the vehicle in the normal riding position. Any mention to the use of the vehicle with passenger is to be intended as referred only to the countries where this is allowed. [. . . ] Do not leave the vehicle unattended when the engine is on or the key is inserted into the ignition switch. Do not sit on the vehicle when the stand is down.
N N
N
Release the throttle grip (Pos. In case of a brief stop, keep at least one brake on.
Rotate the key (2) and move the ignition switch (3) to position "m". 42 (POSITIONING THE VEHICLE ON THE STAND).
aCAUTION
It is not necessary to close the fuel tap when the engine is off, since it is equipped with an automatic closing system.
aCAUTION
Never leave the key in the ignition switch.
N
Stop the vehicle, see beside (STOPPING). Move the engine stop switch (1) to position "m" (for the countries where required).
Lock the steering, see p. 41
use and maintenance SR 50 - SR 125 - SR 150
0/3)4)/. ). ' 4(% 6%()#, % /. CENTRE STAND N Grasp the left handgrip and the left rear grab rail (1). N Push down the stand lever (2).
35''%34)/. 3 4/ 02%6%. 4 4(%&4 NEVER leave the ignition key inserted and always use the steering lock. Park the vehicle in a safe place, possibly in a garage or a protected place. If possible, use the appropriate aprilia "Body-Guard" armored cable &, or an additional anti-theft device. Make sure that all documents are in order and the road tax has been paid.
Write down your personal data and telephone number in the space provided in this page, to facilitate the identification of the owner in case of finding after theft. TELEPHONE NO. :. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
NOTE
Very often stolen vehicles are identified thanks to the data written on the use/maintenance manual.
42
use and maintenance SR 50 - SR 125 - SR 150
-!). 4%. !. #%
aWARNING
Risk of fire. Keep fuel and other flammable substances away from the electrical components. Before beginning any maintenance operation or any inspection of the vehicle, stop the engine, extract the key from the ignition block, wait until the engine and the exhaust system have cooled down and if possible lift the vehicle by means of the proper equipment, on firm and flat ground. Before proceeding, make sure that the room in which you are working is properly ventilated.
Keep away from the red-hot parts of the engine and of the exhaust system, in order to avoid burns. Do not hold any mechanical piece or other parts of the vehicle with your mouth: the components are not edible and some of them are noxious or even toxic.
aCAUTION
If not expressly indicated otherwise, for the reassembly of the units repeat the disassembly operations in reverse order. In case any maintenance operation has to be carried out, it is advisable to use latex gloves.
Normally, the routine maintenance operations can be performed by the user; however, in some cases the use of specific tools and technical expertise may be required. If you need assistance or technical advice, consult your aprilia Official Dealer, who can ensure you prompt and accurate servicing. Ask your aprilia Official Dealer to test the vehicle on the road after a repair or periodic maintenance operation. In any case, personally carry out the "Preliminary checking operations" after any maintenance operation, see p. 35 (PRELIMINARY CHECKING OPERATIONS).
use and maintenance SR 50 - SR 125 - SR 150
43
2%'5, !2 2%'5, !2 3%26)#% ). 4%26!, 3 #(!24 x OPERATIONS TO BE CARRIED OUT BY THE APRILIA Official Dealer (WHICH CAN BE CARRIED OUT EVEN BY THE USER). Key = check and clean, adjust, lubricate or change, if necessary; = clean; = change; = adjust.
Component Battery - Terminal fastening Electrolyte level Spark plug Carburettor - idling Air cleaner Accelerator operation Brake locking operation Light system Stop light switches Brake fluid 2 stroke oil Headlight beam direction - operation Wheels/tyres and inflation pressure Front and rear brake pad wear
After running-in Every 4000 km Every 8000 km [500 km (312 mi)] (2500 mi) or 12 (5000 mi) or 24 months months
NOTE Carry out the maintenance operations more frequently if you use the vehicle in rainy and dusty areas or on uneven ground.
every 500 km (312 mi): every month: every 2000 km (1250 mi):
44
use and maintenance SR 50 - SR 125 - SR 150
OPERATIONS TO BE CARRIED OUT BY THE APRILIA Official Dealer. [. . . ] NGK BR7 HS NGK BR8 HS 0, 5 - 0, 6 mm 210 kPa (2, 1 bar) C. D. I.
210 kPa (2, 1 bar) 230 kPa (2, 3 bar)
19° ± 1° before T. D. C. at 4000 rpm NGK BR8 ES BOSCH WR3CC; CHAMPION RN2C; CHAMPION QN2C 0, 6 - 0, 7 mm
1 Standard
Spark plug gap
82
use and maintenance SR 50 - SR 125 - SR 150
Description Battery Fuses Generator (with permanent magnet) Low beam High beam Front parking light Low / high beam
.
12 V - 4 Ah 7, 5 A 12 V - 85 W 12 V - 15 W
12 V - 6 Ah 15 A - 5 A 12 V - 150 W 12 V - 55 W H3 12 V - 55 W H1 12 V - 5 W 12 V - 10 W 12 V - 5 W 12 V - 21 W
+
ELECTRIC SYSTEM
C%K-_ C%K-_
Direction indicators Rear parking light Stoplight Front parking light
12 V - 35/35 W 12 V - 3 W
BULBS
-_
Number plate Number plate
AC%K
12 V - 3 W 12 V - 1, 2 W 12 V - 1, 2 W 12 V - 1, 2 W 12 V - 2 W 12 V - 2 W 12 V - 1, 2 W
12 V - 3 W
Dashboard lighting High beam WARNING LIGHTS High beam C % K - _ Direction indicators 2 stroke oil reserve Low fuel
use and maintenance SR 50 - SR 125 - SR 150
83
x , 5"2)#!. 4 #(!24 Transmission oil (recommended): F. C. , SAE 75W - 90 or GEAR SYNTH, SAE 75W - 90. As an alternative to the recommended oil, it is possible to use high-quality oils with characteristics in compliance with or superior to the A. P. I. Mixer oil (recommended): As an alternative to the recommended oil, use high-quality oils with characteristics in compliance with or superior to the ISO-L-ETC++, A. P. I. [. . . ]