User manual AUDIO ANALOGUE CRESCENDO CD

[. . . ] ) has permitted us to increase the cut off frequency of the output filter with very good results on the audio performance of the unit expecially for the increased precision of the listening stage. The problem of this approach is the added distortion and noise due to the number of stages the sound has to pass through but Audio Analogue has used all its experience and technology to carefully design every element of the stage choosing every passive component to reduce the overall distortion and noise with astonishing results!4 INTRODUCTION AUDIO ANALOGUE does not take any responsibilities in the following cases: Whenever the operational procedures related to the use and the maintenance of the equipment as described in this manual are not respected. Whenever damages to the equipment occur because of fixing and modifications made form non-authorized staff or because of normal deterioration of the system. [. . . ] If the amplifier was carried from an extremely cold environment to and extremely hot one, it could create internal condensation, causing possible bad functioning. If this occurs, please wait for at least an hour before using it again, to allow it to gradually reach room temperature. INSTRUCTIONS TO PUT IT OUT OF SERVICE Consult qualified staff Follow the regulations of the current legislation regarding recycling and waste disposal. During playback, starts previous CD track playback, a long pressure ability Fast rewind search. When playback is stopped, it allows choosing the CD track from which resuming playback or search CD tracks backward. During playback, starts next CD track playback, a long pressure ability Fast forward search. When playback is stopped, it allows choosing the CD track from which resuming playback or search CD tracks forward. If necessary, replace them with others of the same kind (see back panel). Description of the remote controller: CD PLAYER Functions PLAY / PAUSE STOP / OPEN PREV / REW NEXT / FFW 0123456789 (NUMERIC KEYS): According to the functioning state of the CD player you have two different actions: - when the CD player is in stop it is possible to select a track pressing the number of the correspondent song (the unit waits for PLAY to be pressed). - When the CD player is playing, pressing the number of the desired song it immediately skips to the indicated track. RPT (REPEAT) This key has different functions according to the functioning state of the CD player: When the CD player is stopped it is possible to choose to repeat a track or the entire disc by pressing the key once or twice. To choose to repeat a track you press the keys PREV and NEXT to select the track to repeat or select the track directly by its number using the numeric keys on the remote. When the CD player is playing, pressing this key in two different moments determines the initial instant (A) and final (B) of an arbitrary section to repeat. When this option is active, you can de-activate it by pressing the key again, and the normal playback of the CD is re-established. SHUFFLE function, this playing mode is enabled with the unit in STOP state and permits random playback of the tracks. While playing you can randomly change the played track with the switches NEXT and PREV on the front panel or on the remote while you can reproduce an established track using the numeric keys on the remote. TIME/Menu: the switch has two different functions: if it is pressed while the unit is playing it activates the Time one, while if is pressed and keep pressed for about one second when the unit is in stop mode it let you enter into the setup menu. Time function: pressing the switch when the unit is playing permits to visualize different information on the reproducing time. The alternative modalities are: - the time that is left until the end of the song, modality "end of track" ( on the display it appears in "_" between the indication of the minutes and the seconds). - The time that is left until the end of the CD, modality "end of disc" (on the display it appears in "-" between the indication of the minutes and the seconds). - The time that has gone by since the beginning of the CD, modality "total time" (on the display it appears in ". Once this is done, press the Time switch and keep it pressed for about a second. [. . . ] If your used electrical or electronic equipment has batteries or accumulator, please dispose of these separately before and according to local requirements. By disposing of this product correctly you will help ensure that the waste undergoes the necessary treatment, recovery and recycling and thus prevent potential negative effects on the environment and human health which could otherwise arise due to inappropriate waste handling. In other countries outside the EU If you wish to discard this product, please contact your local authorities and ask for the correct method of disposal. For Switzerland: Used electrical or electronic equipment can be returned free of charge to the dealer, even if you don't purchase a new product. [. . . ]