User manual AUDIO ANALOGUE PUCCINI SETTANTA REV2.0

[. . . ] INTRODUCTION AUDIO ANALOGUE does not take any responsibilities in the following cases: Whenever the operational procedures related to the use and the maintenance of the equipment as described in this manual are not respected. Whenever damages to the equipment occur because of fixing and modifications made form non-authorized staff or because of normal deterioration of the system. No part of this manual can be reproduced by any means, transmitted or copied for private or public use without private authorization from AUDIO ANALOGUE. The information contained in this manual is related to the data kept by AUDIO ANALOGUE at the moment of the issue o f this publication; AUDIO ANALOGUE has the right to make changes to this document without prior notice. [. . . ] Do not place objects on the supply cable and check that this is not positioned in way through. If liquid entered the equipment, the plug should be disconnected from the socket avoiding to touch the metal parts. Competent technical staff should be asked to check the equipment before operating it again. Keep the equipment far from sources of heat such as the solar light, kitchens, radiators etc. Always Switch off and unplug the supply cable before cleaning the equipment externally. If the amplifier was carried from an extremely cold environment to and extremely hot one, it could create internal condensation, causing possible bad functioning. If this occurs, please wait for at least an hour before using it again, to allow it to gradually reach room temperature. INSTRUCTIONS TO PUT IT OUT OF SERVICE Consult qualified staff Follow the regulations of the current legislation regarding recycling and waste disposal. If you press this button when the unit is in Stand-by mode, it will activate. Sixteen blue leds around the volume knob progressively indicate the volume level. Record player ground connector (to be used only when phono in is in use) PH/1. If necessary, replace them with others of the same kind (see back panel). When pressed and immediately released, it activates/deactivates standby mode. When muting is activated, volume level is reduced to background level and the volume leds start blinking. If one of the items listed above is missing, please contact your Audio Analogue retailer. After extracting the smallest items from the package, pull out the unit carefully. Where to place Puccini Settanta Puccini Settanta is a complex unit that may generate a large quantity of heat. In particular, you should leave at least 5cm around and above the unit and avoid placing it close to heat sources (radiators, heaters, amplifiers, television sets). Plugging and connecting Puccini Settanta Before connecting Puccini Settanta to the sources, please be sure that they're all unplugged from wall outlets. First of all, connect the sources to the Puccini Settanta inputs you want to use. as the second step , connect Puccini Settanta outputs to the speakers' cable. At last, plug the power cord into the Puccini Settanta inlet and into the wall outlet. [. . . ] in this case , the main channel outs of the multi-channel processor have to be connected to the Puccini Settanta in selected for the bypassing. To select the input you want to by-pass, hit the key SET on the remote control, select the input to by-pass and than hit SET again to confirm. To activate bypassing it is sufficient to press the "STBY" button on the remote controller for a few seconds when the amplifier is on: on the amplifier front panel will switch-on the led light corresponding to the by-passed input and the two led lights placed on top of volume knob. To de-activate by-pass, hit the STBY button again on the remote control and the amplifier will go back to normal mode. [. . . ]