User manual BALAY 3FEB2215

[. . . ] An autho rized electrician should install and connect your ap pliance. Use of this appliance without an earth connection or incorrectly installed can cause serious injuries (injuries or electrocution), although this is very rare The manufacturer does not accept any responsibility for any inappropriate use or for any injury caused by incorrect electrical installation. Electrical connection or installation Safety precautions This appliance is intended only for domestic use. This produkt is not intended for use by young children or infirm persons without supervision. 5 Cooking and heating food During their cooking, food such as stews, soups, sauces or drinks may heat up too quickly without any indication, spilling out of the cookware. It is therefore advisable to heat this type of food gently, selecting a suitable power level and stirring the contents before and during cooking. [. . . ] Check that your pans are attracted by a magnet to find out if they are suitable. If no pan is placed on the hotplate, or the pan is not made of a suitable material or it is not a suitable size, the number on the hotplate indicator, showing the power level, will flash. If you take longer than ninety seconds to place a suitable pan on the hotplate, it will automatically turn itself off. Main switch with childproof lock Main switch Switch on the electronics in the control panel using the main switch. Switching on Switching off Touch the @ symbol until the - hotplate indicators light up. All hotplates are switched off The residual heat indicator remains lit until the hotplates have cooled sufficiently. The hob switches off automatically if all the hotplates have been switched off for more than 10 seconds. If there is still residual heat available when the hob is switched back on, H/h and - flash alternately in the hotplate indicator. Notes 13 Childproof lock To prevent children from switching on the hotplates, you can secure the hob against being switched on inadvertently. Activating the childproof lock Switch on the hob using the @ main switch. 1. Turn off the hotplates, one by one, starting with the bottom right hotplate and anticlockwise. 3. Touch the main @ switch for at least 5 seconds, after which time a signal will sound. Operating the hob To switch on, touch the @ main switch for more than 4 seconds. This buzzer can be turned off: Switch on the hob using the main switch. 1. Turn off the hotplates, one by one, starting with the bottom right hotplate and anticlockwise. 3. Touch the main switch for at least 5 seconds, after which a confirmation signal sounds. Proceed in the same manner as for switching off. Care and cleaning Do not use high pressure cleaners or steam jets. Care Clean your hob using a protective/care product for glass ceramic. It makes cleaning easier. Cleaning glass ceramic Cleaning agents Clean the hob after each use. Water marks can also be removed using lemon juice or vinegar. 20 Unsuitable cleaning agents Do not use: Abrasive sponges, scouring pads or aggressive cleaning agents, such as oven spray or stain remover. The casing may scratch the ceramic surface. Glass scraper d How to clean the glass ceramic cooking surface The blade is very sharp. Use a cleaning product and kitchen towel to clean the surface when it is luke warm. Discoloration is caused by pan abrasion or the use of unsuitable cleaning agents. Our after sales service can remove discoloration, but will charge for this service. Food residues and spills can impair the function of the control panels. Shimmering metallic discoloration Control panels Cleaning the hob surround Only use warm soapy water. [. . . ] If the symbol continues to appear contact the technical assistance service. F2 it is turned off by touching the control surface if the hob has cooled down sufficiently. If after connection F4 appears again, call the technical assistance service. To continue cooking touch any sensor. F display and numbers Visual indication F0 Fault An internal error was produced while the hob was working. F2 The cooking hob is too hot and has turned off. [. . . ]