User manual BALAY 3VE352ND annexe 1

[. . . ] en Dishwasher summary of instructions Brief and handy: everything your dishwasher needs . . . Before using for the first time, read the operating instructions! Adjusting the water softening Read off the correct setting for your system * Ask your water supply water hardness company what the water hardness is and enter . . . °dH °fH °Clarke mmol/l Set value on the appliance 0 0­1, 1 1 2 3 Quickly sorted . . . How to adjust the water softening system ­ Rotate the programme button from the 12 o'clock position by one notch to the left. [. . . ] Deviations is practice are possible. Power consumption in kWh Water consumption in litres 130 1, 80 19 125 1, 75 19 140 1, 05 16 75 1 17 35 0, 90 13 15 0, 10 5 9000 194 655 Switch on the appliance Here we go . . . Close the door. Press the main switch, programme sequence display lights up. Additional programmes ** Soaking . . . of utensils in the bottom basket, programme starts automatically, 5 g of extra detergent on the open door!reduces washing time reduces drying time Flexibility . . . Half load . . . for a few items, saves water, energy and time Switch off the appliance Everything o. k. . . . When the "end of programme" display lights up, switch off the main switch. Turn off the tap. ** some models Maintenance and care Strainers . . . Check, if required, clean Rotate filter cylinder, remove filter system . . . For perfect rinsing results . . . rinse under flowing water . . . Screw in filter system NOTE MARK! Cleaning the waste-water pump * * With some models ­ Ladle out water and remove filters ­ Unscrew cover (Torx T20) ­ Check area of fan impeller for foreign objects ­ Screw in cover and insert filters Spray arms . . . Remove blockages/deposits Pull lower arm upwards . . . Unscrew upper arm . . . Clean spray nozzles under flowing water (perhaps with toothpick) . . . Insert lower arm . . . Screw in upper arm Rectifying minor faults yourself . . . Fault Possible causes . . . as it is worth doing it yourself! Remedial action Fault Possible causes Remedial action Residual water in the appliance Waste water pump blocked The programme has not yet ended Clean waste-water pump (see above). Close the appliance, switch on and wait until the programme ends ("end of programme" display lights up) or terminate programme (see Terminating the programme). Utensils are not clean Sand or gritty residue on the utensils Utensils are situated close together or one above the other Too little detergent Unsuitable programme selected Spray arm nozzles blocked Filters dirty, not seated firmly Spray arms blocked Separate the utensils, prevent contact points. [. . . ] Switch on the main switch again. Terminating the programme . . . ­ While the programme is running, rotate the programme selector to the Reset pos. ­ When the programme has run, switch off the main switch. Loading the dishwasher correctly . . . Dishwasher-proof utensils (not soiled with ash, wax, lubricating grease, ink or adhesive labels; remove large remnants of jam, milk products and food according to the operating instructions and check that the spray arms can rotate freely. [. . . ]