User manual BALAY 3VF911NB

[. . . ] caused by stumbling, open the dishwasher only briefly in order to load and unload the dishwasher. ­ Read and observe the safety information and instructions for use on the packaging for cleaning and rinsing agents. ã=Warning Knives and other utensils with sharp points must be placed horizontally in the cutlery drawer. Children in the household ­ If fitted, use the childproof lock. These may cause chemical burns in the mouth, throat and eyes or asphyxiation. The water in the rinsing compartment is not drinking water and could contain detergent residue. [. . . ] The programme starts running. Ï Intensive zone * Perfect for a mixed load. You can wash very soiled pots and pans in the lower basket together with normally soiled utensils in the upper basket. The spray pressure in the lower basket is intensified, the rinsing temperature is increased slightly. ¿ Extra drying * An increased temperature during the final rinse and an extended drying phase ensure that even plastic parts dry better. There is a slight increase in the energy consumption. 15 en Optical display while the programme is running * * depending on model While the programme is running, a light spot shines on the floor under the appliance door. Do not open the dishwasher door until the light point is no longer visible on the floor. If the appliance is installed at eye-level, with flush furniture front, the light point is not visible. ­ Hold down programme button # and press START button ` until : . . . . The LED for button # flashes and the digital display h displays the factory setting : . ­ Press programme button # until the factory set value : is indicated on the digital display h. To change the setting: ­ By pressing the button 3, you can switch the function off : or on :. ­ Close the door. Timer programming * * depending on model You can delay the start of the programme in 1-hour steps up to 24 hours. The filter system consists of a coarse filter, a flat fine filter and a microfilter. ­ Unscrew filter cylinder as illustrated and take out filter system. Overall condition of the machine ­ Check spray arm for grease and limescale deposits. If you find such deposits: ­ Fill detergent dispenser with detergent. Start the appliance without utensils in the programme with the highest rinsing temperature. Clean the appliance with detergents/ appliance cleaners which are particularly suitable for use with dishwashers. Regularly wipe the front of the appliance and fascia with a damp cloth; water and a little washing up liquid are adequate. Do not use sponges with a rough surface or abrasive detergents, as these could scratch the surfaces. Stainless steel appliances: To prevent corrosion, avoid using sponge cloths or wash them out thoroughly several times before using for the first time. ã=Warning Never use other chlorinated household detergents!Health hazard! Special salt and rinse aid ­ Check the refill indicators @ and H. If required, refill salt and/or rinse aid. ­ Remove any residue and clean filters under running water. ­ Re-install filter system in reverse sequence and ensure that the arrow marks are opposite each other after closing the filter system. 18 en Spray arms Limescale and contaminants in the rinsing water may block nozzles and bearings on the spray arms 12 and 1B. [. . . ] ­ A power cord extension may be purchased from customer service only. ­ Use only a residual current operated circuit-breaker which features the symbol , . Only this extension guarantees compliance with the currently valid regulations. Please note the system will not function unless the power supply is connected. Transportation Empty the dishwasher and secure loose parts. [. . . ]