User manual BALAY 3VS932IA

[. . . ] instruction manual 9000 460 749 (8909-1) EN Dishwasher y www. balay. es 1 2 34 56 7 8 9 10 Reinigen fertig in 1:08 Std. ABC 12 11 Reset 3 sec. 20 21 22 23 24 25 26 27 28 29 30 31 32 33 en Table of contents Washing the dishes . 16 16 16 16 16 17 17 17 18 18 18 18 19 19 19 19 19 20 20 21 21 22 22 22 23 23 24 24 24 25 25 25 26 26 26 27 27 27 27 28 28 28 Safety instructions . 16 en Safety instructions Delivery ­ Check the packaging and dishwasher immediately for damage caused in transit. ­ Please dispose of the packaging material in an environmentally friendly manner. [. . . ] ­ Press programme button # until the factory set value : is indicated on the digital display 8. Each time the button is pressed, the set value increases by one level; when the value of : has been reached, the display jumps back to : (off). ­ Close the door. Timer programming You can delay the start of the programme in 1 hour steps up to 24 hours. ­ Press the button ` + until is flaching in the timer programming display X. ­ Press + or ­ button until the ` displayed time corresponds with your requirements. ­ To delete timer programming `, press the + or ­ button until is indicated on the digital display X. You can change your programme selection at any time until the programme starts. ­ Close the door. 17 en Automatic switch off after end of programme or interior light* * depending on model To save energy, the dishwasher can be automatically switched off 1 min or 120 min after the programme ends. The interior light 1" comes on when the door is opened irrespective of whether the ON/OFF switch ( is switched on or off. If the door is open for longer than 60 min. , the light switches off automatically. The interior light 1" is lit only when the set value : is selected. Appliance switches off after 120 min. Switching off the appliance Short time after the end of the programme: ­ Open the door. ­ Remove the utensils when they have cooled down. ã=Warning At the end of the programme please open the door fully and not partially when emptying the dishwasher. Any escaping water vapour could damage sensitive worktops. Interrupting the programme ­ Open the door. If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring open or water to run out of the appliance. ­ Hold down programme button # and press START button )" until : . . . The LED for button # flashes and the digital display 8 displays the factory setting : . Each time the button is pressed, the set value increases by one level; when the value of : has been reached, the display jumps back to : . ­ Close the door. Terminating the programme (Reset) ­ Open the door. ­ Close the door. 18 en Changing the programme When the START button )" has been pressed, the programme cannot be changed. The only way a programme can be changed is by Cancel programme (Reset). Maintenance and care A regular inspection and maintenance of your machine will help to prevent faults. [. . . ] Drain the appliance according to the following steps: ­ Turn on the tap. The expected programme duration is indicated on the numerical display 8. ­ Press START button )" until : is indicated on the digital display. (This prevents residual water from running into the machine control and damaging the programme sequence. ) Removing the appliance Also observe the sequence of worksteps here. [. . . ]