User manual BOSCH DHU626M

[. . . ] They contain important information concerning your personal safety as well as on use and care of the appliance. Please retain the operating and installation instructions for a subsequent owner. dispose of packaging materials properly (see Installation instructions). dispose of packaging materials properly (see Installation instructions). [. . . ] When cleaning the filters by hand, soak them in hot soapy water first of all. Then brush the filters clean, rinse them thoroughly and leave the water to drain off. Press the catch on the grease filters Insert the clean filters back into the hood. Caution: As the filter becomes more and more saturated with grease, there is an increased risk of fire and the function of the extractor hood may be impaired. Mounting: Remove the cover W by rotating the O knobs to 90° , fit the filter inside and lock in place with the central knob O, then close the cover. Replacing the activated carbon filters: The saturation of the activated charcoal Occurs after more or less prolonged use, depending on the type of cooking and the regularity of cleaning of the grease filter. In any case it is necessary to replace the cartridge at least every 4 mounths. The activated carbon filters are available from specialist outlets (see Optional accessories). Disposal of old activated carbon filters: Activated carbon filters do NOT contain any harmful substances. Disconnect the extractor hood from the electricity supply by pulling out the mains plug or switching it off at the fuse box. At the same time as you clean the grease Filters, clean off any grease from all accessible parts of the housing. This significantly reduces the fire hazard and ensures that the extractor hood performs as effectively as possible. Use a hot detergent solution or a mild window cleaner to clean the canopy of the extractor hood. Do not scrape off any dirt that has dried on but loosen it up with a damp cloth. Do not use abrasive cleaning agents or sponges that could cause scratches. Note: Do not use alcohol (spirit) on plastic parts, otherwise the surface may become matt in appearance. Clean the sliding switch with a soft, damp cloth (mild detergent solution) only. Clean the surface in the same direction as it has been ground and polished. Do not use any of the following to clean stainless steel surfaces: abrasive sponges, cleaning agents containing sand, soda, acid or chloride!Aluminium and plastic surfaces: Use a soft, non-linting window cloth or micro-fibre cloth. Switch off the extractor hood and pull out The mains plug or switch off the electricity supply at the fuse box. Plug the appliance into the mains or If you have any questions or if a fault occurs, please call Customer Service. [. . . ] The complete installation set can be obtained from specialist outlets. The corresponding accessory numbers can be found at the end of these operating instructions. The mains power supply must correspond to the rating indicated on the plate situated inside the hood. If provided with a plug connect the hood to a socket in compliance with current regulations and positioned in an accessible area. [. . . ]