User manual BOSCH GSB 12V-35

[. . . ] Read all safety warnings, instructions, illustrations and specifica- Save all warnings and instructions for future reference. The term "power tool" in the warnings refers to your mains- Work area safety U Keep work area clean and well lit. U Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. unmodified plugs and matching outlets will reduce risk of electric shock. [. . . ] Failure to observe the safety and general instructions may result in electric shock, fire and/or serious injury. Please observe the illustrations at the beginning of this operating manual. intended use The power tool is intended for driving and loosening screws and for drilling in wood, metal, ceramic and plastic. The GSB is also designed for impact drilling in brick, masonry and stone. product Features The numbering of the product features refers to the diagram of the power tool on the graphics page. A) Accessories shown or described are not included with the product as standard. You can find the complete selection of accessories in our accessories range. Driving application according Typically, the A-weighted noise level of the power tool is Sound pressure level Vibration total values ah (triax vector sum) and uncertainty K determined according to EN 62841-2-1, EN 62841-2-2: Drilling into metal: The vibration level and noise emission value given in these instructions have been measured in accordance with a standardised measuring procedure and may be used to compare power tools. They may also be used for a preliminary estimation of vibration and noise emissions. The stated vibration level and noise emission value represent the main applications of the power tool. However, if the power tool is used for other applications, with different application tools or is poorly maintained, the vibration level and noise emission value may differ. This may significantly increase the vibration and noise emissions over the total working period. To estimate vibration and noise emissions accurately, the times when the tool is switched off or when it is running but not actually being used should also be taken into account. This may significantly reduce vibration and noise emissions over the total working period. Implement additional safety measures to protect the operator from the effects of vibration, such as servicing the power tool and application tools, keeping their hands warm, and organising workflows correctly. assembly U Remove the battery from the power tool before carrying out work on the power tool (e. There is risk of injury from unintentionally pressing the on/off switch. charging the Battery U Use only the chargers listed in the technical data. Only these chargers are matched to the lithium-ion battery of your power tool. To ensure full battery capacity, fully charge the battery in the charger before using your power tool for the first time. The lithium-ion battery can be charged at any time without reducing its service life. The lithium-ion battery is protected against deep discharge by the "Electronic Cell Protection (ECP)". [. . . ] There is risk of injury from unintentionally pressing the on/off switch. U To ensure safe and efficient operation, always keep the power tool and the ventilation slots clean. after-Sales Service and Application Service Our after-sales service responds to your questions concerning maintenance and repair of your product as well as spare parts. You can find explosion drawings and information on spare parts at: www. [. . . ]