User manual BOSCH GSR 12V-35 FC

[. . . ] Read all safety warnings, instructions, illustrations and specifica- Save all warnings and instructions for future reference. The term "power tool" in the warnings refers to your mains- Work area safety U Keep work area clean and well lit. U Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. unmodified plugs and matching outlets will reduce risk of electric shock. [. . . ] A) Accessories shown or described are not included with the product as standard. You can find the complete selection of accessories in our accessories range. Noise emission values determined according to EN 62841-2-1, EN 62841-2-2. Typically, the A-weighted sound pressure level of the power tool is 73 dB(A). The vibration level and noise emission value given in these instructions have been measured in accordance with a standardised measuring procedure and may be used to compare power tools. They may also be used for a preliminary estimation of vibration and noise emissions. The stated vibration level and noise emission value represent the main applications of the power tool. However, if the power tool is used for other applications, with different application tools or is poorly maintained, the vibration level and noise emission value may differ. This may significantly increase the vibration and noise emissions over the total working period. To estimate vibration and noise emissions accurately, the times when the tool is switched off or when it is running but not actually being used should also be taken into account. This may significantly reduce vibration and noise emissions over the total working period. Implement additional safety measures to protect the operator from the effects of vibration, such as servicing the power tool and application tools, keeping their hands warm, and organising workflows correctly. fitting U Remove the battery from the power tool before carrying out work on the power tool (e. There is risk of injury from unintentionally pressing the on/off switch. Removing the battery (see figure A) U Use only the chargers listed in the technical data. Only these chargers are matched to the lithium-ion battery of your power tool. To ensure full battery capacity, fully charge the battery in the charger before using your power tool for the first time. The lithium-ion battery can be charged at any time without reducing its service life. The lithium-ion battery is protected against deep discharge by the "Electronic Cell Protection (ECP)". When the battery is discharged, the power tool is switched off by means of a protective circuit: The application tool no longer rotates. U Do not continue to press the On/Off switch after the power tool has automatically switched off. To remove the battery (5), press both release buttons (4) and pull the battery downwards out of the power tool. [. . . ] Do not dispose of power tools and batteries/rechargeable batteries into household waste!Only for EU countries: According to the Directive 2012/19/EU, power tools that are no longer usable, and according to the Directive 2006/66/EC, defective or used battery packs/batteries, must be collected separately and disposed of in an environmentally correct manner. Battery packs/batteries: Li-ion: Please observe the notes in the section on transport (see "Transport", page 19). Undgå at bære elværktøjet med fingeren på afbryderen og sørg for, at elværktøjet ikke er tændt, når det sluttes til nettet, da dette øger risikoen for personskader. [. . . ]