User manual BOSCH SENSIXX B22L TDS2242

[. . . ] Thank you for buying the Sensixx B22L steam station, the new steam-ironing system from Bosch. Carefully read through the operating instructions for the appliance and safeguard them for future reference. Introduction These instructions for use contain valuable information about the unique features of this system and some hints to make ironing easier for you. Open out the first page of the booklet, this will help you to understand how the appliance works. [. . . ] At the beginning of each use, it is possible that drops of water will be dispensed alongside steam. Therefore, it is advisable to try the iron on the ironing board or a piece of cloth to start with. Tip : for better ironing results, iron the last strokes without steam to dry the garment. (model dependent) This system has intelligent steam control, which, after releasing the steam release button (17), provides a small amount of additional steam. The additional steam can always be stopped by briefly pressing the steam release button once again. the "PulseSteam" function helps soften stubborn garments like jeans or linen faster. When the steam release button is activated, the steam generator will release three powerful shots of steam so that the steam reaches even deeper into the fabrics. Or (model dependent) Press the steam release button (17) on the bottom of the handle two times in quick succession (double-click). Some water drops may appear when you use the "PulseSteam" function for the first time. The water drops will disappear after you have used the function for some time. This can be used to remove creases from hanging clothes, curtains etc. Never direct the steam jet at garments that Never aim the steam at people or animals. Set the temperature control knob to at least the Hold the iron in an upright position 15 cm away From the garment being steamed. You can steam iron curtains and hanging garments (jackets , suits , coats. ) by placing the iron in a vertical position and pressing the steam release button (17-18*). energy saving button (model dependent) If the "Energy saving" button (8*) is switched on, you can save up to 25% of the energy and 40% of the water consumption (*), and still achieve good results when ironing most of your garments. It is advisable to use the normal energy setting only for thick and very wrinkled fabrics. Note: If you work with the "Energy saving" function, the variable steam regulation and temperature regulation can still be used as recommended. If during ironing, the steam release button (17-18*) on the iron handle is not pressed for a certain length of time (8 minutes), the steam station will automatically switch off. The "auto shut-off" pilot lamp (9) will flash when auto shut-off has been activated. To switch the steam station back on, press the steam release button again. To extend the life of your steam generator and to prevent any build up of scale, it is essential that you rinse out the filter (4) and the boiler after several hours of use. [. . . ] The water is condensing inside · Point the iron away from the ironing The pipes because steam is being area and press the steam release Used for the first time or has not The steam generator contains too · Problem Dirt comes out through the soleplate. Water spots appear on the garment during use of the "PulseSteam" function. This is a regular consequence of continued use over a long period of time. Steam release button has been activated for too long a period of time, that is, it has been pressed too frequently. [. . . ]