User manual BOSCH TCA5201

[. . . ] Filling the system When switched on for the first time, the water pipes in the appliance must be filled. The appliance is ready for use when the Warning Do not press the power switch while the appliance is operating. The appliance should only be switched off when it is in stand-by mode. When the stand-by button a lights Green, the appliance is ready for operation. [. . . ] Float The float 19 in the water tray 18 shows when the tray needs emptying. If the float 19 is clearly visible, empty the This fully automatic espresso/coffee machine grinds beans freshly for each brew. If possible, use only beans for fully automatic coffee and espresso machines. deep-freeze or store in a cool place in sealed , airtight containers. The tank must always contain sufficient water for operating the appliance. To restore the factory setting of approximately 125 ml, simply reset the appliance. Tip: Pre-warm cups, especially small, thick espresso cups, by placing on the cup shelf 14 or rinsing with hot water. Place the prewarmed cup(s) under the The coffee is brewed and dispensed into the cup(s). Coffee delivery stops automatically when the selected quantity has been dispensed (factory setting approx. At any time by pressing the coffee It is possible to dispense the same amount of coffee a second time. just press the coffee dispensing button 5 or K within 3 seconds after brewing is complete. Reset: Switch the appliance to stand-by and remove the trays 17 and 18. Press the stand-by button a to switch the The appliance must be ready for use. This function allows water to be heated for a cup of tea, for example. Push the sleeve on the nozzle 8 all the Risk of scalding When the dial is set to g/h, the nozzle may sputter a little. End the process by turning the dial 6 Steam for foaming milk Steam for heating drinks The appliance must be ready for use. You can foam the milk first and add the coffee on top, or foam the milk separately and pour it into the coffee. Push the sleeve on the nozzle 8 all the I The appliance will heat up for approx. Immerse the nozzle 8 deep into the milk, But do not let it touch the bottom of the cup. Risk of scalding When the dial 6 is set to g/h, the nozzle 8 may sputter. I To foam more milk, press the steam button h again and repeat the whole process. Push the sleeve on the nozzle 8 all the I The appliance will now heat up for Immerse the nozzle 8 deep into the liquid you want to heat. [. . . ] Starting the service programme Switch the appliance to stand-by mode using the stand-by button a. The S LED starts to flash and the Appliance rinses the coffee dispenser through twice. Fill the water tank with lukewarm water, add descaling agent and dissolve completely (total liquid: 0. Or pour prepared descaling mixture into the water tank (total liquid: 0. [. . . ]