User manual BRINKS BHS-3000

[. . . ] Consumer Information FCC Notice This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] Housekeepers, guests, and housesitters can all be given auxiliary codes. You can assign as many as 91 codes, but for your security, you should limit the number of auxiliary codes you assign, and delete any codes that are not in use. Enter the number of the user to whom you want to assign a code (1 to 91). The keypad beeps. AUX CODE AUXILIARY CODES ENTER MASTER CODE 1. Press the OPTIONS key until the message window reads: AUXILIARY CODES, ENTER MASTER CODE. 2. Enter the number of the user to whom you want to assign a code (1 to 91). Test the new code by turning the system on, then using the code to turn the system off. 5. Test the new code by turning the system on, then using the code to turn the system off. 19 20 How to Delete an Auxiliary Code If you wish to delete an auxiliary user code, do the following: 1. Press the OPTIONS key. The ENTER CODE light blinks. Press the OPTIONS key until the message window reads: AUXILIARY CODES, ENTER MASTER CODE. AUX CODE 3. Enter the master user code. The message window reads: ENTER USER #. 4. USER NUMBER Enter the number of the user whose code you wish to delete. The ENTER CODE light blinks. 3. USER NUMBER Enter the number of the user whose code you wish to delete. The window reads: ENTER NEW CODE. 5. Do not enter the user's code. The keypad beeps. 6. Test that the code has been deleted by attempting to turn the system on and off using the deleted code. 5. Test that the code has been deleted by attempting to turn the system on and off, using the deleted code. 21 System Testing You can test the components of the system--the sirens, the telephone hook-up, and the sensors--without causing a false alarm. This section describes how you can be sure that the system is functioning properly. Important Notice: Test Weekly Your Protective Service Agreement requires you to conduct these tests every week. Siren and Transmission Test This test helps to ensure that the system's siren is working properly, and that the system is able to send an alarm signal to the Brink's Monitoring Center. To test the system's siren and transmission, do the following: 1. If you do not hear the beep or blast, and the TROUBLE light turns on, the test failed. Press the OPTIONS key until the message window reads: TEST, ENTER CODE. TEST 2. If you do not hear the beep or blast, and the keypad message window reads CP TROUBLE, the test failed. Call 1-800-445-0872. 22 Testing All Burglary Sensors This test helps to ensure that the system's burglary sensors are working properly. Make sure there is nothing moving near the motion detector and that the READY light is on. [. . . ] If you refer a new customer to Brink's, and that customer has a Brink's Home Security system installed, you will receive one month of monitoring free. Please have the person you referred write your name and telephone number in the space provided at the bottom of their contract. Contact Brink's Customer Care at www. mybrinks. com or call 1-800-445-0872. Your account will be credited within 60 days of the installation date. [. . . ]