User manual BRITAX BABY-SAFE SLEEPER

[. . . ] € Never leave your baby unattended in the carrycot when placing it on elevated surfaces (e. The plastic parts of the carrycot heat up in the sun, so that your baby may get burnt. 1 Adjusting the handle You can engage the handle in three positions: Simultaneously press both buttons 4 on the handle 5. Then whilst holding the buttons pressed 4 turn the handle 5 backwards or forwards until it engages in the desired position. [. . . ] Pull the green tag 31 at the head end 20 to pull the D ring 12 out fully. If the D-Ring 12 will not pull out, the backrest 6 is still in upright position. Hook the vehicle seat belt fitting 18 at the centre rear seat onto the D ring 12 at the head end 20 of the carrycot. Make sure that the lap belt sections 15 are tightened up and run from their anchoring points 14 in the seat surface directly to the vehicle seat belt fitting 18. Pull on the shell of the carrycot to check that it is securely installed. 2 Removing from the vehicle Grip the seat belt fitting 18 with both hands and rotate it forward to loosen the seat belt slightly. Continue to rotate the fitting 18 until they unhook from the D rings 12. For day-to-day use, you can leave the fittings 18 fasted to the vehicle seat belts. Always remove the fittings 18 before using the vehicle seat belts to secure other child seats or persons. Swivel the red latch 17 to the side and pull the vehicle seat belt out of the vehicle seat belt fitting 18. 3 Checklist to ensure that your carrycot is installed correctly in the vehicle For your baby's safety, check that. € the carrycot is fastened crossways to the direction of travel, • the child's head is on the side away from the vehicle door. € the carrycot is fastened with two vehicle seat belts, • the vehicle seat belt is tightened up and not twisted, • the vehicle seat belt for the centre rear seat is hooked onto the head end 20, 4. Utilisation comme nacelle de poussette Please refer to the operating instructions supplied with your pram. The carrycot can be used as a pram attachment on all Britax frames which are marked with the "type A" carrycot icon and which have been approved for use with a pram attachment. A fitting raincover is available in the specialized trade as accessories. For the protection of your baby Pour protéger votre bébé WARNING!Carrycots, pushchairs and buggies must be only used to transport babies or children. 43 For the protection of your baby • Pour protéger votre bébé • WARNING!Make sure that the pram attachment is securely connected to the pram. € Always apply the brake before fitting the pram attachment onto the pram or removing it. € The pram attachment is only suitable for carrying babies who cannot yet sit up by themselves. [. . . ] This is not a material defect, but rather a normal sign of wear which is not covered by the warranty. Buckle: Buckle malfunction is often due to accumulations of dirt and dust which may stop it from working properly. 69 Please contact your retailer directly in the event of a warranty claim. when processing claims , product-specific depreciation rates will be applied. [. . . ]