User manual BRITAX EDEN ROCKER

[. . . ] NOTES CARE AND MAINTENANCE Regularly inspect and maintain your product to ensure the freedom of movements of the locking devices and security of components. To prolong the life of your nursery product keep it clean and do not leave it in the direct sunlight for extended periods of time. [. . . ] To maintain the safety of your nursery product, seek prompt repairs for bent, torn, worn or broken parts. Always check parts regularly for tightness of screws, nuts and other fasteners tighten if required. THIS PRODUCT IS NOT INTENDED FOR COMMERCIAL USE. 06 www. britax. com. au www. britax. com. au 03 1. A ADJUST THE CANOPY Adjust the canopy to the desired position by either pushing up or pulling out. TO ADJUST THE SEAT ANGLE Turn the knobs located on both sides of the rocker anticlockwise to loosen. The seat angle is adjustable to three recline positions, tilt the seat to the desired position, then turn the knobs clockwise to lock the seat into position. TO ATTACH TOY BAR AND TOYS Attach the toy bar by fitting the mouldings to the base of the canopy frame. Attach toys to the bar by fitting the strap located at the top of the toy bar through the loop in the top of the toy. 5. A TO USE THE HARNESS Place baby in the rocker and position the crotch strap between baby's legs. A B B Release the lap strap buckle by squeezing the buckle prongs until released. [. . . ] To revert to the rocking position, rotate rear leg stand forward. Note: strap and www. britax. com. au 04 The crotch a webbingthe lower harness straps also have end. Ensure webbing www. britax. com. au end sits flat against the slot moulding as shown in illustration A. 05 [. . . ]