User manual BT DIGITAL BABY MONITOR
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual BT DIGITAL BABY MONITOR. We hope that this BT DIGITAL BABY MONITOR user guide will be useful to you.
Manual abstract: user guide BT DIGITAL BABY MONITOR
Detailed instructions for use are in the User's Guide.
[. . . ] Make sure the Baby Unit and mains adapter cable are kept out of reach of your baby at least one metre away. Never place the Baby Unit inside your baby's cot, bed or playpen. with clothes, towels or blankets).
I
Never use or place your Parent or Baby Units in moist places or near water. If travelling abroad, make sure that the voltage shown on the mains power adapter corresponds to the local mains power before connecting to the power supply. [. . . ] Using your finger or a coin, turn the battery lock on the back of the Baby Unit anticlockwise so the groove is horizontal then lift off the cover. Replace the battery cover, turning the battery lock into the vertical position again to lock it.
Please note The Baby Unit will only work from the batteries if the mains power is off or disconnected.
!Using an incorrect adapter may permanently damage the Baby Monitor.
Battery performance The recommended batteries are 4 x AA Alkaline (2500mAh). Unlock Lock With new batteries, your Baby Unit will give up to 24 hours continuous performance with the night lights switched off. When the Baby Unit is not being used and is disconnected from the mains power, you should ensure you remove the batteries. This will prevent the batteries discharging.
Check the connection
When both Units are switched on, the green link lights on both Units will come on. If the link between the Units is broken at any time, the link lights on both units will turn red and flash slowly. At the Parent Unit, you will also hear an alert signal (3 beeps) to warn you that there is no communication between the Units. If this happens, check that the mains power is plugged in and switched on at the Baby Unit. Also check that the Units are within range of one another.
In the event of power failure, when the power is restored all your settings will remain unchanged.
BT Digital Baby Monitor Edition 3 26. 02. 04 5918
6
Getting to know your Parent Unit
From the Parent Unit you can listen to your baby and operate the Baby Unit by remote control.
Volume + - / Up and Down Set volume. Talk Press to talk to your baby.
Power on/off Press and hold to switch the power on or off. Sound sensitive lights Green and then red lights indicate the noise level in your baby's room. Battery Low light Flashes when the batteries are low.
Link light Green when the Baby and Parent Units are linked. Red if the Parent and Baby Units are not linked.
Charging
Charge light The red light comes on when the Parent Unit is charging.
BT Digital Baby Monitor Edition 3 26. 02. 04 5918
Getting to know your Baby Unit
Night light on/off Press to switch the starry night lights on and off. Volume + Press to adjust the Talk Back volume.
7
BT Digital Baby Monitor
Power on/off Press and hold to switch the power on or off. Power socket Microphone Allows you to hear your baby via the parent unit.
Back of Unit
Battery lock Child tamper proof lock for the battery compartment.
BT Digital Baby Monitor Edition 3 26. 02. 04 5918
8
Using the Baby Monitor
Switching on/off
Helpline If you have any problems using your BT Digital Baby Monitor, call 08702 40 47 45 or email helpline@btbabymonitors. co. uk. Helpline open 9. 00am 5. 30pm, Monday to Friday and 9. 00am 2. 00pm on Saturday.
On both Parent and Baby Units 1. To switch On, press until the link light comes on and the display activates. At the Parent Unit the red and green sound sensitive lights illuminate briefly to confirm they are working. Or, To switch Off, press until you hear a beep.
Adjust volume
If you place the Parent and Baby Units too close together you will hear a high pitched noise, this is normal. The units are designed to be located at a distance from one another, e. g. in separate rooms.
There are 5 volume levels on each Unit and there is also an Off setting on the Parent Unit. [. . . ] Scroll or to select the sensitivity level you require level 1 for low sensitivity, or level 5 for high sensitivity.
BT Digital Baby Monitor Edition 3 26. 02. 04 5918
10
Help
Helpline If you have any problems using your BT Digital Baby Monitor, call 08702 40 47 45 or email helpline@btbabymonitors. co. uk. Products over 28 days old from the date of purchase may be replaced with a refurbished or repaired product. Within the 12 month guarantee period: If you experience difficulty using the product, prior to returning it, please read the Help section on page 10 and if necessary call the BT Baby Monitor Helpline on 08702 40 47 45. They will advise you what to do should you need to return your product.
The conditions of this guarantee are: The guarantee shall only apply to defects that occur within the 12 month guarantee period. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE BT DIGITAL BABY MONITOR
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual BT DIGITAL BABY MONITOR will begin.