User manual CANDY FCPK606X

[. . . ] 1 FAQ PROBLEMA Il forno non si scalda Il forno non si scalda Il forno non si scalda POSSIBILE CAUSA Il blocco bambini è attivo Le regolazioni necessarie non sono impostate SOLUZIONE Disattivare il blocco bambini Assicurarsi che le impostazioni necessarie siano corrette L’orologio non è impostato Impostare l’orologio IT 15 Safety Indications • WARNING: the appliance and accessible parts become hot during use. €WARNING: the accessible parts can become hot when the grill is in use. €WARNING: ensure that the appliance is switched off before replacing the bulb, to avoid the possibility of electric shocks. €WARNING: in order to avoid any danger caused by the accidental resetting of the thermal interruption device, the appliance should not be powered by an external switching device, such as a timer, or be connected to a circuit that is regularly switched on and off. [. . . ] Keep the seals clean and in order, to avoid any heat dispersal outside of the cavity. If you have an electric contract with an hourly tariff, the "delayed cooking" programme makes energy saving more simple, moving the cooking process to start at the reduced tariff time slot. 6 Declaration of compliance The parts of this appliance that may come into contact with foodstuffs comply with the provisions of EEC Directive 89/109. By placing the mark on this product, we are confirming compliance to all relevant European safety, health and environmental requirements which are applicable in legislation for this product. Collects the residues that drip during the cooking of foods on the grills. 3 First Use PRELIMINARY CLEANING Clean the oven before using for the first time. Wash all accessories and wipe inside the oven with a solution of hot water and washing up liquid. Set the empty oven to the maximum temperature and leave on for about 1 hour, this will remove any lingering smells of newness. The first operation to carry out after installation, or after a power cut, is to set the time of day (a power cut has occured if the display is flashing 12:00). 200°-> The temperature LED “°” flashes until the displayed temperature is reached. HOT -> When a programme finishes, if the oven is still hot, the display shows "HOT", alternating with the time, even if the knobs are positioned to OFF. EN 22 FUNCTION SILENCE MODE HOW TO ACTIVATE • Rotate the left function selector to the position " Silence mode “ • Rotate the left function selector to the position “Set the time”. € Allow to use the oven as alarm even if the oven is switch off MINUTE MINDER • Turn the left function selector to the position Minute Minder. € Set the time of cooking by using buttons “+”and “-” • Turn the left function selector to the position Child lock. € Press the button " + " during 5 seconds • Child lock is available when " STOP " appears on display • Set the time on 00. 00 by turning the left function selector to the position Minute Minder, and using the button " - “ • Turn back the left function selector to Child lock and press button " + " during 5 seconds. 2 Cooking Modes Function Dial T °C default T °C range Function (Depens on the oven model) LAMP: Turns on the oven light. The fan circulates air at room temperature around the frozen food so that it defrosts in a few minutes without the protein content of the food being changed or altered. 240 the shelf on the second level from top, or to defrost bread pizza or pastry by positioning the shelf on the lower level. the temperature is preset in 60°C constant , no regulation is possible. FAN COOKING: We recommend you use this method for poultry, pastries, fish 50 ÷ 240 and vegetables. Heat penetrates into the food better and both the cooking and preheating times are reduced. [. . . ] On the display appears the indication "END" until the door is locked then "0--n". 5- You can turn the function selector back to " 0 " but if the temperaure is still high, the "0--n " indication appears to inform that the door is locked. Use of the pyrolytic cycle in Touch Control ovens: 1- Rotate the function selector into position pyrolisys. The display will show either "ECO" or "SUP“ 2- The pre-set time is 65 minutes but it can be varied from 65 min. [. . . ]