User manual CARDO SCALA-500

[. . . ] With the headset turned off, press and hold the Control Button for ten seconds until the red and blue Status Lights begin flashing. Search for Bluetooth devices on your phone by following the phone's instructions. After a few seconds the phone will list the scala-rider TeamSet as a discovered device. Select it and follow your phone's instructions to accept the pairing. [. . . ] Your headset can pair with up to eight phones, and will automatically connect to the last phone connected to the headset. 5 The Passenger Unit (green logo): This unit is solely intended for intercom connection with the driver and it cannot initiate or receive a phone call. To turn on the Passenger Unit, press the Control Button until the blue Status Light illuminates. NOTE: The Driver and Passenger Units are already factory-synchronized for Intercom communication with each other, and do not require any synchronization by you. SYNCHRONIZING INTERCOM BETWEEN THE PASSENGER AND DRIVER HEADSETS The two headset units (Driver and Passenger units) are supplied factory synchronized for Intercom communication with each other. Therefore, you do not need to perform the synchronization between these devices. However, if you have purchased these units separately and not in the TeamSet Retail box, you need to synchronize the devices yourself by proceeding as follows: 1. Simultaneously press and hold the Intercom Buttons of both devices for at least 10 seconds while watching the Status Light on the Passenger unit. Once the Status Light on the Passenger unit lights steady red, wait three seconds and then release both Intercom Buttons. If successful, the steady red Status light on the Passenger unit will switch to a steady blue light for a few seconds, then begin flashing blue. If the synchronization has failed, the steady red Status light on the Passenger unit will turn off without switching to steady blue for a few seconds, and you must repeat the synchronization procedure. 6 ATTACHING THE SCALA-RIDER UNITS TO YOUR HELMETS Perform this procedure for both the driver and passenger helmets. Use the enclosed Allen Wrench to loosen the two screws on the Back Plate. Repeat the pairing process as described in TURNING THE DRIVER HEADSET ON FOR THE FIRST TIME, page 5. Your phone supports only the Bluetooth headset profile and not the handsfree profile. Therefore you must use the Control button to answer or terminate calls. Make sure that the VC feature is activated (see Driver's Unit Functions, page 9) 4. The VC feature works well while driving up to 70 km/h or 44 mph with a 3/4 helmet and up to 120 km/h or 75 mph with a closed full faced helmet. The Redial feature works only with mobile phones that also support the Bluetooth handsfree profile. Check whether your phone supports this profile. 13 Battery does not provide at least five hours of talk time I'm trying to reject incoming calls by remaining silent, but the phone continues to ring. Red Status Light does not light steady when charger is connected. I hear crackling noises Sound deteriorates when the phone is in my back pocket. 1. When the headset is connected to the charger and it is fully charged, the red Status Light turns off. Reject feature works only with mobile phones that support Bluetooth hands-free profile. Make sure the Charging Jack is firmly plugged into the headset and wait 5 seconds 2. [. . . ] Make sure the Charging Jack is firmly plugged into the headset and wait 5 seconds 2. If you have a GSM phone and your headset is too close to phone, noises may be heard. (10 m) apart or there are major obstacles (such as concrete walls) between the headset and mobile phone. Some mobile phones emit weaker Bluetooth signals than others, resulting in reduced sound quality, especially when the phone is close to your body. [. . . ]