User manual CARDO SCALA-RIDER TEAMSET

[. . . ] Connect the wall charger to the headset's Charging Jack (located between the two Volume buttons). While charging, the red Status Light illuminates (it may take up to 15 seconds until the red Status Light illuminates). [. . . ] 6 ATTACHING THE SCALA-RIDER UNITS TO YOUR HELMETS Perform this procedure for both the driver and passenger helmets. Use the enclosed Allen Wrench to loosen the two screws on the Back Plate. Slide the Back Plate between the internal padding and the external shell of the helmet. (If the external shell is too thick, use the supplied plastic Extension Pad by loosening the screws and fitting the extention pad between the Back Plate and the main body of the clamp). Adjust the clamp's location so that the microphone is located in front of your mouth, and then tighten the screws. Attach the speakers to the Velcro inside your helmet opposite your ears (short speaker cord for left ear & long speaker cord for right ear), or use the supplied Velcro pad. Allen Wrench Back Plate CORRECT INCORRECT NOTE: The microphone must be positioned vertically and not horizontally. 7 4. Slide the headset downwards along the sliding panel until a clicking sound indicates that the headset is locked in place. REMOVING THE HEADSET FROM THE HELMET Your headset can be removed for charging and storage by pressing your finger gently against the tab and sliding the headset up with the other hand. We recommend that you store your headset in the enclosed carrying pouch when not in use. Press here to remove 8 DRIVER'S UNIT FUNCTIONS DESIRED RESULT: G E N E R REQUIRED ACTION: A L F U N C T I O N S Turn on the headset Turn off the headset Increase the volume Decrease the volume P H O N Press the Control Button steadily for at least 6 seconds Press the Control Button steadily for at least 3 seconds Short press the Volume Up Button. Short press the Volume Down Button. E F U N C T I O N S Answer a call Reject a call Terminate a call Voice Dial Redial Enable/Disable voice command feature Short press the Control Button or speak loudly any word of your choice. For some mobile phones you may need to press the Control Button to end the call. During standby, short press the Control Button and state the name of the person you wish to call. This feature is supported only by mobile phones that support the Voice Dial feature. During standby, long press the Intercom Button Long press the volume up and down buttons simultaneously until you hear a beep. The default status is voice command enabled. 9 DRIVER'S UNIT FUNCTIONS (continued) DESIRED RESULT: I N T E R C REQUIRED ACTION: O M F U N C T I O N S Start using the intercom Terminate the operation of intercom Conference Call (add passenger to an active call) End Conference Call (release passenger from a conference call) DESIRED RESULT: Turn on the headset Turn off the headset Start using the intercom During standby, start speaking loudly to activate the intercom Stop speaking. [. . . ] The Redial feature works only with mobile phones that also support the Bluetooth handsfree profile. Check whether your phone supports this profile. 13 Battery does not provide at least five hours of talk time I'm trying to reject incoming calls by remaining silent, but the phone continues to ring. [. . . ]