User manual CARDO SCALA RIDER SOLO

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual CARDO SCALA RIDER SOLO. We hope that this CARDO SCALA RIDER SOLO user guide will be useful to you.


CARDO SCALA RIDER SOLO : Download the complete user guide (556 Ko)

You may also download the following manuals related to this product:

   CARDO SCALA RIDER SOLO (554 ko)
   CARDO SCALA RIDER SOLO (550 ko)
   CARDO SCALA RIDER SOLO (550 ko)
   CARDO SCALA RIDER SOLO (531 ko)
   CARDO SCALA RIDER SOLO (334 ko)
   CARDO SCALA RIDER SOLO (569 ko)
   CARDO SCALA RIDER SOLO (549 ko)
   CARDO SCALA RIDER SOLO DATASHEET (698 ko)
   CARDO SCALA RIDER SOLO DATASHEET (1187 ko)
   CARDO SCALA RIDER SOLO DATASHEET (1155 ko)
   CARDO SCALA RIDER SOLO DATASHEET (752 ko)
   CARDO SCALA RIDER SOLO DATASHEET (914 ko)
   CARDO SCALA RIDER SOLO DATASHEET (1124 ko)
   CARDO SCALA RIDER SOLO DATASHEET (939 ko)
   CARDO SCALA RIDER SOLO DATA SHEET (620 ko)

Manual abstract: user guide CARDO SCALA RIDER SOLO

Detailed instructions for use are in the User's Guide.

[. . . ] If the connection between the phone and headset is lost, tap the CTRL button to reconnect the devices. With the scala rider Solo headset turned OFF, press and hold the CTRL Button until the Red and Blue Lights begin rapidly alternating. Search for Bluetooth devices on your phone by following the phone's instructions. Please consult your phone's User Manual for more information. IMPORTANT: The scala rider Solo is a water-resistant device, designed for use under moderate rain or snow conditions. [. . . ] Fasten the Clamp to the Glue Plate using the Allen screws that were previously removed. POSITIONING THE SPEAKERS Attach the speakers to the Velcro inside your helmet opposite your ears (short Speaker A speaker cord for the left ear [A] and the long speaker cord [B] for the right ear). Using two speakers inside the helmet may be prohibited in certain jurisdictions. If this is the case, you should tuck away the long corded speaker underneath the helmet padding as follows: Caution: This process can be done only once!Use the enclosed Allen Wrench to remove both Allen screws and release the Helmet Clamp's back plate. Determine the location on the helmet where the Helmet Clamp must be attached. 6 scala rider® SoloTM Cable Lead the speaker cord [B] alongside the rim of the padding to the right side and then back to the left side, near speaker [A]. Then place the speaker [B] underneath the padding. Speaker B AUDIO SOURCES AND PRIORITIES The different Audio Sources that are connected to the scala rider Solo are prioritized as follows: Highest: 1. Mobile phone audio (Incoming/outgoing calls) / GPS device (GPS audio and navigation instructions) Lowest 2. MP3 Connectivity A high priority Audio Source will always interrupt any lower priority Audio Source. Mobile phone call overrides MP3 Player English Speaker B Speaker A USING THE HEADSET GENERAL USAGE GENERAL FUNCTIONS DESIRED RESULT: Turn on the headset Turn off the headset REQUIRED ACTION: Press the CTRL Button steadily for at least three seconds. Tap the Volume Up Button Tap the Volume Down Button ATTACHING AND REMOVING THE HEADSET FROM THE HELMET CLAMP ATTACHING: Slide the headset downwards along the sliding panel until a clicking sound indicates that the headset is locked in place. REMOVING: Your headset can be removed for charging and storage by pressing your finger gently against the tab and sliding the headset up with the other hand. We recommend that you remove the headset from the helmet when not in use. Press here to remove Increase the volume Decrease the volume AGC (Automatic Gain Control): In addition to manual Volume Control, the scala rider Solo will automatically increase and reduce its volume according to ambient noise and driving speed. scala rider® SoloTM 7 INITIATING AND RECEIVING MOBILE PHONE CALLS Voice Recognition ­ VR (VOX) The VR feature allows you to answer or reject incoming calls by voice Control without having to remove your hands from the handlebars. Each time you switch off and turn on the headset, the VR feature will be automatically enabled. To disable / enable the VR feature press and hold the Volume Up and Volume Down simultaneously for three seconds during Standby. You will hear an ascending / descending tone confirming the change each time you switch this feature ON or OFF respectively. Note: The VR feature works well while driving up to 70km/h or 44m/h with 3/4 helmet and up to 120km/h or 75m/h with a closed fullface helmet. NOTE: If your Bluetooth mobile phone is paired to a Bluetooth GPS device, not directly to the scala rider Solo, some of the above Phone functions may not be compatible. STATUS LIGHTS STATUS LIGHT None Alternating Red/blue flashes 1 blue flash every 3 seconds 1 red flash every 3 seconds 2 red flashes every 3 seconds Solid red STATUS Headset is off Mobile phone/GPS Pairing mode Standby ­ No call is in progress Battery is low Low battery while a call is in progress Charging 2 blue flashes every 3 seconds Call is in progress PHONE FUNCTIONS Answer a call Reject a call Terminate a call Voice Dial Tap the CTRL Button or speak loudly any word of your choice. Tap the Redial/Reject Button or remain silent for 15 seconds during an incoming call. During Standby, tap the CTRL Button and state the name of the person you wish to call. This feature is supported only by mobile phones that support the Voice Dial feature. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. scala rider® SoloTM 9 NOTE: Operate the MP3 Player device by using its buttons (FF/REW/ PLAY/PAUSE). [. . . ] You fully acknowledge our warnings and understand that: (a) risks and dangers exist in using the Device while in traffic, including but not limited to injury or illness, strains, fractures, partial and/or total paralysis, death or other ailments that could cause serious disability; (b) these risks and dangers may be caused by the negligence of the manufacturers or its agents or any third party involved in descala rider® SoloTM 11 English signing or manufacturing the Device; (c) these risks and dangers may arise from foreseeable or unforeseeable causes. You hereby assume all risks and dangers and all responsibility for any losses and/or damages, whether caused in whole or in part by the negligence or other conduct of others, including the Company. You confirm that you have read this release of liability and fully understand its terms and that you have given up substantial rights by not returning the Device for a full refund (see refund option below). Disclaimer of Warranty CARDO DISCLAIMS ALL EXPRESS AND IMPLIED WARRANTIES WITH REGARD TO THE ENCLOSED DEVICE, INCLUDING WITHOUT LIMITATION ANY IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, AND NON-INFRINGEMENT. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE CARDO SCALA RIDER SOLO




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual CARDO SCALA RIDER SOLO will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.