User manual CARDO SCALA RIDER TEAMSET

[. . . ] The cover tongue protecting the Charging Jack should be kept tightly closed at all times to prevent moisture from entering the device. SET UP FOR MOBILE PHONE CALLS If you have a Bluetooth enabled mobile phone and would like to make and receive phone calls using the SCALA RIDER TeamSet Driver's unit, you must first pair your headset to the mobile phone. Once the headset is paired to a specific mobile phone during this Setup Procedure, they will remain paired and automatically recognize each other whenever they are within range. If the connection between the phone and headset is lost, tap the CTRL button to reconnect the devices. With the Driver's unit headset turned OFF, press and hold the CTRL Button until the Red and Blue Lights begin rapidly alternating. 4 BEFORE USING (CHARGING THE HEADSET) Make sure that the headset is fully charged for at least four hours before initial use. [. . . ] Therefore it is recommended to not use the headset during this 24 hour period. Fasten the Clamp to the Glue Plate using the Allen screws that were previously removed. SCALA RIDER® TeamSetTM | POSITIONING THE SPEAKERS Attach the speakers to the Velcro inside your helmet opposite your ears (short speaker cord for the left ear [A] and the long speaker cord [B] for the right ear). Using two speakers inside the helmet may be prohibited in certain jurisdictions. If this is the case, you should tuck away the long corded speaker underneath the helmet padding as follows: Lead the speaker cord [B] alongside the rim of the padding to the right side and then back to the left side, near speaker [A]. Then place the speaker [B] underneath the padding. Speaker A Speaker B Cable Speaker A B Speaker REMOVING: Your headset can be removed for charging and storage by pressing your finger gently against the tab and sliding the headset up with the other hand. We recommend that you remove the headset from the helmet when not in use. Press here to remove English AUDIO SOURCES AND PRIORITIES The different Audio Sources that are connected to the SCALA RIDER TeamSet are prioritized as follows: 1. Mobile phone audio (Incoming/outgoing calls) / GPS Highest: device (GPS audio and navigation instructions) 2. MP3 Connectivity A high priority Audio Source will always interrupt any lower priority Audio Source. AUDIO SOURCES AND PRIORITIES ­ Passenger Unit Passenger can also initiate intercom calls with drivers unit as well as listen to music from his MP3 Player. Intercom call overrides the audio from the MP3 player. Speaker B ATTACHING AND REMOVING THE HEADSET FROM THE HELMET CLAMP ATTACHING: Slide the headset downwards along the sliding panel until a clicking sound indicates that the headset is locked in place. 7 USING THE MP3 PLAYER WITH YOUR HEADSET Your SCALA RIDER headset can be connected to an MP3 player/audio device by simply plugging it to the Helmet Clamp's jack with the audio cable as follows: | SCALA RIDER® TeamSetTM 1. Power on the headset to have it on Standby mode, flashing slowly in Blue. Connect one side of the audio cable to your MP3 player/audio device's jack and the other side to the helmet Clamp's jack as shown in the photo. Operate the MP3 Player/audio device by using its buttons (FF / REW / PLAY / PAUSE ). INITIATING AND RECEIVING MOBILE PHONE CALLS Voice Recognition (VR) Connect the audio cable to the helmet Clamp's jack NOTE: Volume can only be adjusted through the MP3 Player. The audio signal will return only when headset is once again in Standby mode. The VR feature allows you to answer or reject incoming calls by voice Control without having to remove your hands from the handlebars. Each time you switch off and turn on the headset, the VR feature will be automatically enabled. Note: The VR feature works well while driving up to 70km/h or 44m/h with 3/4 helmet and up to 120km/h or 75m/h with a closed full-faced helmet. During standby, start talking loudly to activate the Intercom Stop talking. Tap the Volume Up Button Tap the Volume Down Button English INTERCOM FUNCTIONS­Driver's Unit GENERAL DESIRED RESULT: Start using the intercom Terminate operation of Intercom Conference Call (add passenger to an active call) End Conference Call (release passenger from a conference call) FUNCTIONS REQUIRED ACTION: During standby, start talking loudly to activate the feature Stop talking. During a conference call, tap the intercom button. Note: In case the person on the other side of the intercom is not responding and you start talking, 2 beeps will alert you that the other side is not available STATUS LIGHTS STATUS LIGHT None Alternating Red/blue flashes 1 blue flash every 3 seconds 2 blue flashes every 3 seconds 1 red flash every 3 seconds 2 red flashes every 3 seconds Solid red Note: In case the person on the other side of the intercom is not responding and you start talking, 2 beeps will alert you that the other side is not available STATUS Headset is off Mobile phone/GPS Pairing mode Standby ­ No call is in progress Call is in progress Battery is low Low battery while a call is in progress Charging 9 STATUS LIGHTS STATUS LIGHT None One blue flash every 3 seconds Steady red (Charger is connected) Steady red (Charger is not connected) STATUS Headset is off Headset is on Headset is being charged Headset in Intercom pairing mode | SCALA RIDER® TeamSetTM SUPPORT For additional information please visit our website at www. cardosystems. com FAQ: www. cardosystems. com/faq or contact us at: support@cardosystems. com Phone: USA and Canada: + 1-800-488-0363 International: +4989 450 36819 Operation is subject to the following two conditions: 1) this device may not cause interference and 2) this device must accept any interference, including interference that may cause undesired operation of the device. FCC RF Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. [. . . ] Cardo Systems, Inc. , including its Officers, Directors, Affiliates, Parent Company, Representatives, Agents, Contractors, Sponsors, Employees, Suppliers and Resellers (jointly referred to as the "Company" or "Cardo") strongly advises you to take all necessary precautions and remain alert to the traffic, weather and road conditions if you choose to use the SCALA RIDER TeamSet headset, including all derivative models irrespective of its commercial name or branding (the "Device"), and stop your Vehicle on the roadside prior to initiating or receiving calls. Any publications, advertisements, announcements or similar notes that refer to using the Device while riding a Vehicle are solely intended to address its technical capabilities and should not be misconstrued as if encouraging users to operate the Device while actively involved in traffic. 11 | SCALA RIDER® TeamSetTM assume all risks and dangers and all responsibility for any losses and/or damages, whether caused in whole or in part by the negligence or other conduct of others, including the Company. You confirm that you have read this release of liability and fully understand its terms and that you have given up substantial rights by not returning the Device for a full refund (see refund option below). Disclaimer of Warranty CARDO DISCLAIMS ALL EXPRESS AND IMPLIED WARR ANTIES WITH REGARD TO THE ENCLOSED DEVICE, INCLUDING WITHOUT LIMITATION ANY IMPLIED WARR ANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, AND NON-INFRINGEMENT. [. . . ]