User manual CHANEY INSTRUMENT MODEL 00735 WIRELESS THERMOMETER AND REMOTE SENSOR

[. . . ] Both the main unit and the sensor unit can be displayed on a desktop or hung on a wall. For desktop display pull out the foldable stand located on the back of the unit. To hang on a wall, slide the hanging slot located at the top center of the unit over a nail or screw (not provided) in the wall. [. . . ] To activate icon appears on the auto scroll, press the - button until the LCD display. Temperature Trend Indicator: If the temperature changes more than 1 degree in an hour, 1 of 3 temperature trend icons will appear, indicating steady, falling, and rising temperatures. MIN/MAX/MEMORY: The main unit automatically stores the high and low temperature. Pressing the max/min button will display the maximum temperature for 5 seconds. Press the button again to display the minimum temperature for 5 seconds. To clear the stored temperature, press the clear button while the value you wish to clear (max or min) is displayed. TEMPERATURE ALERT: Minimum and maximum temperature alerts can be programmed. Setting Cycle: To set the temperature at which the alert will sound, press the alert button for 3 seconds until the outdoor temperature and the upper/lower icon flash. Press the + or - button to select the desired channel; press the alert button to confirm the channel selection. Enter the desired upper limit temperature by pressing the +/- buttons; press alert to confirm. Enter the desired lower limit temperature with the +/- buttons; press alert to confirm and exit the temperature alert mode. When the temperature reaches either the upper or lower limit, the pointers and the temperature begin to flash and an alarm will sound. The temperature will continue to flash until the temperature changes from the upper or lower limit temperature. THERMOMETER SET-UP: 1. Place batteries in the main unit by removing the battery cover panel on the back of the unit and inserting 2 AA alkaline batteries. Note: The battery panel is located behind the foldable stand/ mounting plate, which can be gently pried from the back of the unit. Before replacing the battery cover press the reset or the Tx button to send a signal to the main unit. On the main unit, select between Celsius and Fahrenheit temperature readings by pressing the + C/F button. To add an additional sensor make sure batteries are in the main unit first, then place batteries in the additional sensor and press the reset or Tx button. [. . . ] Sensor units may have outside interference that is preventing proper transmission. Sources of interference include but are not limited to metal surfaces, electrical devices, etc. The sensor may need to be relocated if interference continues. C. LIMITED WARRANTY: Should this product from the Chaney Instrument Co. [. . . ]