User manual CHANEY INSTRUMENT MODEL 00786 WIRELESS THERMOMETER WITH HUMIDITY

[. . . ] BUTTON FUNCTIONS: BUTTON FRONT BUTTONS PRESS BUTTON ONCE PRESS & HOLD FOR 3 SECONDS Enter clock & calender set mode Enter alarm set mode N/A (no function) Delete current channel reading Fast forward through settings Fast backwards through settings Time zone selection (P/M/C/E) N/A (no function) 00786 Wireless Indoor/outdoor Weather Station H I J TX C/F Home Receiver Remote Sensor Bracket Stand SET ALARM Start or stop radio controlled time signal search Read alarm time for 5 seconds for 5 seconds STEP ONE: SETTING UP THE WIRELESS THERMOMETER Home Receiver Set Up: For the initial installation, always insert batteries in the home unit first, and then the remote sensor. Remove the battery cover on the back and install 2 "AA" batteries (not included) according to the polarity indicated. Remote Sensor Set Up: Remove the bracket stand and remove the 4 screws with a small phillips head screwdriver. [. . . ] Selecting the ideal location: Like a typical AM radio, the Atomic Clock will not receive the WWVB signal in places surrounded by heavy concrete or metal panels. The time signal reception is also greatly affected by electrical or electronic interference. If the home receiver location you selected does not work, change to a location in another part of the room or building. Radio Controlled Time Reception Set Up: The clock attempts to synchronize with the Atomic time signal AUTOMATICALLY right after the first sensor is registered. The unit will start synchronizing the clock after registering the remote sensor thermometer reading. The clock will not respond to any manual settings while attempting to receive the Radio Control Time Signal. Entering The Time Zone: After the unit successfully synchronizes withthe atomic time signal, the time zone must be entered. · Press & hold "C/F ZONE" button on the back of the home reciever for 3 seconds, press "C/F ZONE" button to select P/M/C/E time zones. The letters appear in the area where the seconds are shown in the time display. When you select thecorrect time zone, press the "SET" button to confirm your choice and exit the selection mode. P = P acific Standard Time M = Mountain Standard Time C = Central Standard Time E = Eastern Standard Time 1 STEP THREE: MANUALLY SETTING THE CLOCK & CALENDAR Press and hold the "SET" button for 3 seconds: · The setting sequence is: Year > Month > Date > Hr > Min > 12/24 hr > DST on/off > Weather Offset > EXIT Settings · Press the "+" or "-" buttons on the back of the Receiver to set each function to the correct setting. Once the display is showing the correct setting, press the "SET" button to confirm your settings and to advance to the next function. · The corresponding digits will be flashing during the setting procedure. · After completing the setting sequences pressing the "SET" button will return the display to the standard view. ADDITIONAL FEATURES Setting the Alarm: Press and hold the "ALARM" button for 3 seconds. · The display will show the alarm set time and the letters "AL" appear to the right of the minute digits. · Press the "+" or "-" buttons on the back of the case to set the hours to your desired time. [. . . ] Moon Phase: Moon Phase is shown by the scrolling of the moon icon from left to right. The icon will stop at the existing moon phase for 5 seconds, and then resume scrolling. The clock will not respond to any manual settings while attempting to receive the Radio Control Time Signal. Press the "SET" button to turn the reception off and to enable manual settings. [. . . ]