User manual CHANEY INSTRUMENT MODEL 00804 WIRELESS THERMOMETER WITH HUMIDITY, CLOCK AND REMOTE SENSOR

[. . . ] The next line shows the time which is updated daily via reception of the NIST signal which is broadcast from Fort Collins, Colorado. The Atomix clock also resets it self for Daylight Saving Time each fall and spring. The last line of the display shows the month, date, day of the week and the current phase of the moon. Function When Function When Button Pressed Once Held for 3 seconds SET RCC sync start/ stop enter clock/ cal set (the setting sequence is: Yr > Month > Date > Hr > Min > 12/24hr> DST on/off > EXIT) + 1 step advance in Set Mode, on/off in Normal Mode 1 step backward in set mode, C/ F Rapid advance in the Set Mode Time Zone (PT, MT , CT , ET) in Normal Mode*, rapid backward in Set Mode * hold the - button for 3 seconds and the letter P will flash, press again to select M, C or E. [. . . ] The unit starts synchronizing the clock after registering the remote sensor thermometer reading. The clock will not respond to any manual settings while attempting to receive the Radio Control Time signal. The tower icon in the left hand corner of the screen appears fixed when reception is successful. To turn the reception off and to enable manual settings, press the "­" button. ALARM STOP Press the ALARM button to stop the alarm for 24 hours. The alarm can also be silenced by pressing the "+" button on the back of the unit wit the bell symbol over it. This will turn off the alarm until you press this button again to reactivate it. Radio Controlled (R/C) Time Reception Set Up: The clock attempts to synchronize with SNOOZE / LIGHT Press to enter the SNOOZE mode. A green backlight will also illuminate for 3 seconds each time this button is pressed. MIN/ MAX MEMORY Press the "MIN/ MAX" to view the maximum temperature & humidity values for both indoors & outdoors. The memory will be cleared every night at midnight. Entering the Time Zone: After establishing your time signal, press SET/ ZONE once to select TEMPERATURE & HUMIDITY TRENDS (Outdoor Temp & Humidity) PST/ MST/ CST or EST time zones. A small P, M, C, E icon will appear to the left of the time display for the respective time zone. P = Pacific Standard Time M = Mountain Standard Time C = Central Standard Time E = Eastern Standard Time If the Temperature increases more then 1 degree or the Humidity increase by 3% the Trend arrow will point UP showing a rising trend. If the Temperature change is less than 1 degree or the Humidity changes less than 3% the Trend arrow will be level showing a steady reading. If the Temperature drops more than 1 degree or the Humidity drops 3% the Trend Arrow will point DOWN showing an falling trend. Trend icons update every hour. How to Manually Synchronize Your Atomic Clock: Hold the "­" button for 4 second to trigger a manual synchronization. Icon does not show (No signal received) If signal level is weak and time reception is not successful, move the unit away any source of possible interference and try again in another location. The R/C clock will attempt a daily synchronization at 1:00 AM everyday. If not successful, the R/C clock will search for the time signal every hour. To avoid interference, the unit will disable the other button functions during Radio Controlled Time reception. Simply press the "­" button to turn Radio Controlled Time reception temporarily off. [. . . ] Set to the correct time usint he "+" and "­" buttons on the back of the unit. Press the Alarm button again to exit the set up and return the display to the current time. 3 LIMITED WARRANTY: Should this product from the Chaney Instrument Co. [. . . ]