User manual CHEVROLET GMC YUKON DENALI HYBRID 2011

[. . . ] i-1 ii Introduction Please refer to the purchase documentation relating to your specific vehicle to confirm each of the features found on your vehicle. For vehicles first sold in Canada, substitute the name "General Motors of Canada Limited" for Chevrolet Motor Division and/or GMC wherever it appears in this manual. Keep this manual in the vehicle for quick reference. The names, logos, emblems, slogans, vehicle model names, and vehicle body designs appearing in this manual including, but not limited to, GM, the GM logo, CHEVROLET, GMC, the CHEVROLET and GMC Truck Emblems, TAHOE, YUKON, and DENALI are trademarks and/or service marks of General Motors LLC, its subsidiaries, affiliates, or licensors. This manual describes features that may or may not be on your specific vehicle either because they are options that you did not purchase or due to changes subsequent to the printing of this owner manual. Canadian Vehicle Owners Propriétaires Canadiens A French language copy of this manual can be obtained from your dealer or from: On peut obtenir un exemplaire de ce guide en français auprès du concessionnaire ou à l'adresse suivante: Helm, Incorporated P. O. [. . . ] It tells you much more about how to service the vehicle than this manual can. To order the proper service manual, see "Service Publications Ordering Information" in the owner manual. Before attempting to do your own service work, see "Airbag System Check" in the owner manual. Keep a record with all parts receipts and list the mileage and the date of any service work performed. See "Maintenance Records" in the owner manual. . Vehicle Care 10-3 2 NOTES 10-4 Vehicle Care Engine Compartment Overview 6. 0 L V8 Engine Vehicle Care A. See Drive Motor/Generator Control Module (DMCM) Cooling System on page 109. See Engine Compartment Fuse Block on page 1015. DMCM Coolant Surge Tank Pressure Cap. See Drive Motor/ Generator Control Module (DMCM) Coolant Surge Tank Pressure Cap on page 109. See "Engine Oil" in the owner manual. 10-6 Vehicle Care Change the fluid and filter at the scheduled maintenance intervals listed in Scheduled Maintenance. Be sure to use the transmission fluid listed in Recommended Fluids and Lubricants on page 111. With your foot on the brake pedal, move the shift lever through each gear range, pausing for about three seconds in each range. Keep the engine running and press the Trip/Fuel button or trip odometer reset stem until TRANS TEMP (Transmission Temperature) displays on the Driver Information Center (DIC). Using the TRANS TEMP reading, determine and perform the appropriate check procedure. If the TRANS TEMP reading is not within the required temperature ranges, allow the vehicle to cool, or operate the vehicle until the appropriate transmission fluid temperature is reached. Automatic Transmission Fluid When to Check and Change Automatic Transmission Fluid It is usually not necessary to check the transmission fluid level. The only reason for fluid loss is a transmission leak or overheating the transmission. If a small leak is suspected, then use the following checking procedures to check the fluid level. However, if there is a large leak, then it may be necessary to have the vehicle towed to a dealer service department and have it repaired before driving the vehicle further. Notice: Use of the incorrect automatic transmission fluid may damage the vehicle, and the damages may not be covered by the vehicle warranty. Always use the automatic transmission fluid listed in Recommended Fluids and Lubricants on page 111. How to Check Automatic Transmission Fluid Notice: Too much or too little fluid can damage the transmission. Too much can mean that some of the fluid could come out and fall on hot engine parts or exhaust system parts, starting a fire. Be sure to get an accurate reading if checking the transmission fluid. Apply the parking brake and place the shift lever in P (Park). Vehicle Care Cold Check Procedure Use this procedure only as a reference to determine if the transmission has enough fluid to be operated safely until a hot check procedure can be made. [. . . ] TwoWheel Drive Vehicles Use the following procedure to dolly tow a two-wheel-drive vehicle from the rear: 1. Attach the dolly to the tow vehicle following the dolly manufacturer's instructions. Drive the rear wheels onto the dolly. 10-39 Dolly Towing ­ Rear Towing (Rear Wheels Off the Ground) 3. Secure the vehicle to the dolly following the manufacturer's instructions. [. . . ]