User manual CHEVROLET TAHOE TRUCK NAVIGATION SYSTEM 2010

[. . . ] 56 68 81 82 83 83 83 84 M Radio . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 44 44 47 50 Audio Players Navigation Voice Recognition . . . . . . . . . . i-1 Infotainment System 3 Introduction GMC, the GMC Truck Emblem, and the names SIERRA, SIERRA DENALI, YUKON, and DENALI, HUMMER, the name HUMMER, H2, and the H2 Design are registered trademarks of General Motors. Dolby® is manufactured under license from Dolby® Laboratories. [. . . ] Once a song has been selected "Audio Book Mode" appears on the iPod main screen. Audio Book will only appear as a valid category if this option is on the iPod. Podcasts: Select this button to view the podcasts that have been stored on the iPod. Once a song has been selected "Podcast Mode" appears on the iPod main screen. 42 Infotainment System Podcasts will only appear as a valid category if this option is on the iPod. Touch Files, Folders, or Playlists to show a list of songs stored on the iPod device. If the iPod is disconnected without selecting this button, the files on the iPod could be corrupted. Infotainment System Audio Book Audiobooks can be downloaded from iTunes® or if in . mp3. After inserting the USB or iPod, the following screen displays: 43 2. Touch Audiobooks or Podcasts to show a list of the media stored on the iPod device. 3. Touch the center button to go to the main list menu. 44 Infotainment System To use a portable audio player, connect a 3. 5 mm (1/8 inch) cable to the auxiliary input jack. When a device is connected, the system will detect and automatically begin playing audio from the device over the vehicle's speakers. If a device is connected and you are listening to another source (FM, CD, MP3, etc. ), press the AUDIO key then press the AUDIO key repeatedly until AUX is selected or touch the AUX screen button. An auxiliary device must be connected for the AUX screen button to appear as an option to select or the vehicle must have rear auxiliary jacks. See "Rear Seat Entertainment System" in the Index of your vehicle's owner manual for more information on the rear auxiliary jacks. Auxiliary Devices The navigation system has an auxiliary input jack located in the upper right corner of the faceplate. This is not an audio output; do not plug the headphone set into the front auxiliary input jack. You can however, connect an external audio device such as an iPod, laptop computer, MP3 player, CD changer, or cassette tape player, etc. to the auxiliary input jack for use as another source for audio listening. Drivers are encouraged to set up any auxiliary device while the vehicle is in P (Park). See "Defensive Driving" in the Index of your vehicles owner manual for more information on driver distraction. If your vehicle has rear audio/video input jacks, located in the rear of the center console, they can be used as another source for audio/video listening. Navigation Using the Navigation System This section presents basic information needed to operate the navigation system. Use the hard keys located on the navigation system along with the available touch-sensitive screen buttons on the navigation screen to operate the system. Once the vehicle is moving, various functions will be disabled to reduce driver distractions. Infotainment System Hard Keys The following hard keys are located on the navigation system: system. See AM-FM Radio on page 14 and Satellite Radio on page 22 for more information. 45 O (Power/Volume): Press this knob to turn the system on and off. [. . . ] To cancel this voice tag destination, using voice recognition, push and hold the SRCE button on the steering wheel until you hear a beep, then say "cancel". Canceling voice tag destination by voice recognition, must be done within five seconds after the voice prompt. Infotainment System Radio [band] [select] AM, radio [band] [select] FM, radio [band] [select] XM, radio [band] [select] satellite: These commands instruct the system to go to either the AM, FM, or XM (if equipped). Radio [select] (frequency) AM, radio [select] (frequency) FM: These commands instruct the system to go to a specific frequency on either AM or FM. Radio [select] (channel) XM, radio [select] (channel) satellite: These commands instruct the system to go to a specific channel on the XMTM band (if equipped). [. . . ]