User manual CISSELL MAN383

[. . . ] Forwarrantyservice, contacttheDistributorfromwhomtheCissellequipmentorpartwaspurchased. IftheDistributorcannot bereached, contactCissell. Page 2 TABLE OF CONTENTS Page Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 aey rcuin, pcfctos D s r p i no F a u e . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 ecito f etrs D s r p i n o C n r l P n l . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Loads a position into memory after it had been entered on the keyboard. The NEXT DESIRED POSITION DISPLAY will flash to indicate if the conveyor is in the paused state. Route the connection cable (C2102, supplied with control) between the Conveyor control and the electrical box near the drive on the conveyor. Remove the bottom from the conveyor control and install the connector into the socket on the processor board. Tighten the screws on the plug that attaches it to the socket to prevent it from coming loose. Install the cable bushing into the slot at the rear of the control enclosure and tighten. On the Conveyor end of the cable, connect the leads in the large bundle of 12 wires to the appropriate wires/terminals in the electrical box per the wiring diagram. The small bundle of 4 wires is connected to the digital encoder (attached to the drive shaft) by the small nylon plug. Be sure to properly orient it (match the numbers on the plug to the numbers on the encoder). Go through the SET-UP procedures to input the conveyor parameters into the memory of the conveyor control. The conveyor control is now ready for operation. SETTING CONTROL MODE SWITCH This switch should be in the AUTOMATIC position for normal operation. In this position, the hand/foot switches will work only when the conveyor control is ON. If the conveyor is run with the control turned OFF, the current position will have to be reset. Should the conveyor control have to be removed from the conveyor, move the switch to the MANUAL position to allow the hand/foot switches to work with the control disconnected. Page 7 SETTING UP THE CONVEYOR PARAMETERS AND USING THE CUSTOMIZING KEYS The parameters of the conveyor must be input to the control before it can operate properly. [. . . ] If the entry is correct, press the ENTER key to enter the position into the memory. These can be entered all at once or at any other time even while the conveyor is in the precess of seeking a position. Once a position is brought to the unloading point, it is automatically removed from the memory. [. . . ]