User manual CLARION 935

[. . . ] If the vehicle is equipped with a factory-installed radio, install the source unit with the parts and screws marked (*). (Figure 6) If the vehicle is not equipped with a factory-installed radio, obtain an installation kit to install the source unit in the following procedure. [. . . ] If you have to do any work on the car body, such as drilling holes, consult your car dealer beforehand. # The parts and screws with this mark are used to install radio or included in the installation kit. Place the universal mounting bracket into the instrument panel, use a screwdriver to bend each stopper of the universal mounting bracket inward, then secure the stopper as shown in Figure 4. Insert the source unit into the universal mounting bracket until it locks. Take care of the top and bottom of the outer escutcheon and mount it so that all the hooks are locked. When removing the source unit, disassemble it in the reverse of the order in Section "3. Notes: 1) Some car models require special mounting kits for proper installation. 2) Fasten the front stopper securely to prevent the source unit from coming loose. If it is, replace the fuse with a new one with the same amperage rating as the original one. To replace the fuse, open the lock on the source unit side, remove the old fuse and insert the new one. When the CeNET extension cable is pulled, hold the slide cap part and pull it towards you. Note: Before attaching the universal mounting bracket, slightly bend the spring toward the inside with your fingers and attach it to the side of car. [. . . ] IMPORTANT: Improper installation may cause damage to your unit or car. If you do not have the appropriate experience, consult a qualified installer. [. . . ]