User manual CLARION CDC635

[. . . ] Note : Reinstall these lockscrews when shipping the unit back for repair. During shipment from the factory, the levers are placed in a horizontal position. Never clean the surface of your CDC635/RDC635/RDC634 with chemical solvents, as they could damage the finish. If the car is parked for a long time in the sun during summer or in a cold location during winter, the temperature inside the car will reach extreme levels. [. . . ] When installing at the angle 45°, set the selectors to the center click position. The set may be damaged if the selectors are not set to the proper positions. For horizontal or suspending installation, use the attached installation screw to fix the lead clamp. Use the wing nut to hold in place the installation bracket with bolt to the installation bracket, which is attached to the unit. â¡Vertical Position ¡Horizontal Position ¡Suspending Position 6. Use a knife to cut into the carpet where the bolt can be felt, and allow the bolt to protrude from the carpet. If the unit is played immediately after switching on the heater when the inside of the car is extremely cold, the discs and the pick up will fog up. The fog will naturally disappear in about one hour and thereafter the disc will work normally again. While the system is in play, do not plug or unplug the cables as this will cause damage. Do not expose the magazine to direct sunlight, the car heater or other sources of strong heat. For safety reasons, install the magazine only when the car is stationary. To prevent accidents, it is best that the volume inside the car does not exceed that of the outside. For stubborn dirt, use a soft cloth, lightly moistened with (warm) water and wipe gently. At the recess end of the flip down door lies the built-in pick up which is the core part of the player. If dust or dirt comes into contact with this core part it will cause damage to the the unit. Therefore, do not leave the flip down door open for long periods of time. Read the section on " INSERTING THE CD" carefully and reinsert the CD correctly. Loss of power Magazine cannot be loaded Turn the magazine over to its rear, put your finger on the disc holder release knob and draw out the disc holder. Note : When taking out the CD do not let your fingers touch the signal side of the CD. The installation selector levers are set to different positions on both sides. The unit installation direction and the installation Set the unit installation direction and the installation selector lever positions to match each selector lever positions do not match. When installed at an angle, change the installation selector lever to a position (H, 45V) not prone to noise or sound loss. [. . . ] Never stick labels on the surface of the compact disc or mark the surface with a pencil or pen. In order to prevent short circuits during installation, the negative (­) terminal of the battery must be disconnected prior to installation. Do not use any solvents such as commercially available cleaners, anti-static spray, or thinner to clean compact discs. Do not use compact discs that have large scratches, are misshaped, cracked, etc. [. . . ]