User manual CLARION DCZ625 INSTALLATION MANUAL

[. . . ] THIS PRODUCTION COMPLIES WITH DHHS RULES 21 CFR SUBCHAPTER J APPLICABLE AT DATE OF MANUFACTURE. 50 KAMITODA, TODA-SHI, SAITAMA-KEN, JAPAN. 6 SYSTEM EXAMPLE This unit is available for upgrade in various ways. When you want to upgrade the system, make sure that the upgrade unit fits and wire it correctly. 1 2 4. Remove the separator of the cushion rubber that is attached to the installation bracket with bolt and install accordingly. [. . . ] Noise, skipping Buy New Magazine CAA-397. Note: Only the provided screws and brackets should be used during installation. Using screws other than those specified will cause damage. 2 PRECAUTIONS 2. CD singles cannot be used. · When connecting the CeNET cable, fully insert it. After connection, fix the connector with a clamper as shown in the figure. · When removing the digital optical fiber cable, rotate it to loosen it and pull it gently while holding the slide cap (a gray color part on the source unit). · Do not coil up the digital optical fiber cable with a radius of less than 1" (3 cm). With a radius of less than 1", the performance of the cable will be greatly impaired. · When installed in a glove box or console box, make sure that the source unit cables or cords do not interfere with the opening or closing of the flip down door. 1. The unit must be used with a source unit that has a cable connection for CeNET wire bound (sold separately). q The pickup, the heart of a player, is built in deep behind the door. Do not leave this door open for extended periods to prevent dust adhering to the pickup. q When the inside of the car is very cold and the player is used soon after switching on the heater, dew may form on the disc or optical parts of the player and proper playback may not be possible. If dew forms on the optical parts of the player do not use the player for about one hour and the condensation will disappear naturally to allow normal operation. While the system is in play, do not plug or unplug the cables as this will cause damage. When it is connected to a center unit suitable for CD TEXT display, CD TEXT can be displayed. (When it is connected to a center unit without CD TEXT function, CD TEXT can not be displayed. ) 6. Do not expose the magazine to direct sunlight, the car heater or other sources of strong heat. Replace the CD magazine (CAA-397) with a new one if bent or otherwise damaged. 5 CD MAGAZINE Inserting the CD 1. Put your finger on the disc holder release knob and draw out the disc holder. Magazine Release knob 3. Press in on the disc holder until it locks securely into the magazine. After loading a CD, make sure that it is correctly loaded. Disc inserted upside- Read the section on "Inserting The CD" carefully and reinsert the CD down. The installation selec- Set the installation selector levers to the same position on both sides. [. . . ] Magazine face q Never stick labels on the surface of the compact disc or mark the surface with a pencil or pen. q Never play a compact disc with any cellophane tape or other glue on it or with peeling off marks. If you try to play such a compact disc, you may not be able to get it back out of the CD player or it may damage the CD player. Never touch the surface. · Set the installation selector lever to the same position on both sides. [. . . ]