User manual CLARION DRX5575

[. . . ] Driving on extremely bumpy roads which cause severe vibration may cause the sound to skip. Even in the event that trouble arises, never open the case, disassemble the unit, or lubricate the rotating parts. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] Use of such discs will cause misoperation or damage. No New discs may have some roughness around the edges. to remove roughness from the edge of the disc. Ball-point pen Roughness Do not expose compact discs to direct sunlight or any heat source. No Note: · Do not use commercially available CD protection sheets or discs equipped with stabilizers, etc. These may get caught in the internal mechanism and damage the disc. 6 DRX5575 6. DCP (Detachable Control Panel) The control panel can be detached to prevent theft. When detaching the control panel, store it in the included DCP case to prevent scratches. We recommend taking the detachable control panel with you when leaving the car. CAUTION · The DCP can easily be damaged by shocks. After removing it, place it in a protective case and be careful not to drop it or subject it to strong shocks. · When the release button is pressed and the DCP is unlocked, the car's vibrations may cause it to fall. To prevent damage to the DCP, always store it in a protective case after detaching it. · The rear connector that connects the source unit and the DCP is an extremely important part. Be careful not to damage it by pressing on it with fingernails, pens, screwdrivers, etc. DCP Rear Panel Source Unit Front Removing the DCP 1. Press the MUTE button again to cancel the mute mode. Switching the Clock Display Every time the DISP button 5 is pressed, the display will change between the operation mode and the clock display. Setting the Clock 1) Press the DISP button 5 to display the clock display. Notes: Manual Tuning 1) Press the BND button @, then select FM1, FM2, FM3 or AM. 2) Press and hold the BND button @ for 2 seconds or longer, then the display will show "MANU", which means that a manual selection function is on. 3) Press the SRCH Left/Right button # and select the right station. Seek Tuning 1) Press the BND button @, then select FM1, FM2, FM3 or AM. 2) If the "MANU" on the display is on, press and hold the BND button @ for 2 seconds or longer. When the "MANU" display is off, the Seek Selection function is on. 3) Press the SRCH Left/Right button #, then when it selects the station in which there is a broadcast, it automatically stops. DRX5575 · If · you select another operation mode while you are setting the clock, the clock setting operation will be canceled. If you remove the vehicle's battery for a check or repair, the clock will be reset, so you must set it again. 11 Preset Memory Function Preset Memory Function can store up to 24 stations: six stations for each of FM1, FM2, FM3 and AM. Recalling ISR Press the ISR button 6 then the display will show "ISR", then the radio station previously memorized will be selected. Press the ISR button 6 again to disengage the unit from the Recalling ISR function. · When the present memory function is used, all the content of the memory will be erased. Manual memory function 1) Press the BND button @, and select the band you want to store in the memory. 2) Press the SRCH Left/Right button # then select the station you want to store in the memory. [. . . ] Press the Play/Pause button % again to resume playback. Random Play Press the RDM button 7, then the display will show "RDM", then the entire tracks on the disc will be played at random. Press the RDM button 7 again to disengage the unit from random play. Ejecting the CD Press the Eject button 4, then the CD will be ejected. Note: · If the ejected CD is left as it is, it will be reloaded after 15 seconds. However, single CDs will not be reloaded, so make sure to remove them. Top Function Press the TOP button @, then the CD will start playing from the first song (track number 1). DRX5575 13 CD Changer Mode Operations Listening to the Disc Press the FNC button 3 and select the CD changer mode, then the CD starts playing. Scan Play (Intro Music Scan) Press the SCN button 9, then the display shows "SCN", then the CD will play the first 10 seconds of all the tracks of all CDs. [. . . ]