User manual CLARION DRZ9255

[. . . ] Please read this owner's manual in its entirety before operating this equipment. Check the contents of the enclosed warranty card and keep it carefully with this manual. this manual includes the operating procedures of the CD changer and TV tuner connected via the CeNET cable. The CD changer and TV tuner have their own manuals, but no explanations for operating them are described. [. . . ] â· Set the clock again if you remove the battery for inspection or repairs. GStandard mode <STANDARD>/Multi mode <MULTI> This is used to make various sound adjustments for playback. For details, see "About the Standard mode and Multi mode" (page 18) GDirect mode <DIRECT> This is used to playback tones as they are without adjusting the tones of this unit. The mute function of a selected speaker can be turned ON/OFF by pressing the [ROTARY] knob while the speaker is selected. When you have finished the adjustment, press the [s] button to return to the screen in step 8. When you have finished the adjustment, press the [ ] button to return to the screen in step 6. These two modes can be used to make the following various sound adjustments for playing back music sources: The filter (high-pass filter and low-pass filter) frequency can be set for each speaker according to the characteristics of the speaker. Set the lower limit frequency to be played back mainly on that speaker on the high-pass filter (simply called "HPF" from here on), and set the upper limit frequency on the low-pass filter (simply called "LPF" from here on). The following figure shows the factory default settings for filter frequencies in the Multi mode. Frequency band played back mainly by HIGH (2 kHz onwards) Frequency band played back mainly by MID (500 Hz to 2 kHz) Frequency band played back mainly by LOW (80 kHz to 500 Hz) Frequency band played back mainly by SUB-W (to 80 kHz) Select the Standard mode or the Multi mode according to your speaker configuration. When the filter is set to "THROUGH", the setting for that filter is disabled, and all frequencies are played back. The filter frequency ranges that can be set vary according to the speaker. Note, however, that the frequencies are selected from the value (1/3 octave steps) currently set on this unit. The following filters can be set for each speaker: Effectiveness can be adjusted for each filter (HPF or LPF). "-12dB/oct" is more effective than "-6dB/oct" and "-18dB/oct" is much more effective. Try switching between "-6dB/oct", "-12dB/oct" and "18dB/oct " and select the setting that sounds most natural to you. This function allows you to adjust how much the output level is to be lowered. EQ (Parametric Equalizer) This function allows you to correct in detail all frequency levels by a smooth curve by correcting frequencies matched to the type of your car. This can be adjusted when the Audio mode is the Standard mode or the Multi mode. When you have finished the adjustment, press the [s] button to return to the screen in step 6. Try switching between "NOR" (forward phase) and "REV" (reverse phase) and select the setting that sounds most natural to you. GAbout the time alignment function This function allows you to adjust the speakers so that any listener in the car can obtain the same sound effect from the speakers. [. . . ] "DISC" and "SCN" light in the display and disc scan play starts. "DISC" and "SCN" go off from the display and the current track continues to play. Auto store selects 6 TV stations automatically and stores each one into preset memory. If there are not 6 stations with good reception, stations previously stored in memory remain and only the strong stations are stored into memory. [. . . ]