User manual CLARION K10

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual CLARION K10. We hope that this CLARION K10 user guide will be useful to you.


CLARION K10 : Download the complete user guide (404 Ko)

You may also download the following manuals related to this product:

   CLARION K10 INSTALLATION GUIDE (674 ko)

Manual abstract: user guide CLARION K10

Detailed instructions for use are in the User's Guide.

[. . . ] Clarion will not assume any responsibility for any loss or damage incurred in shipping. ALL IMPLIED WARRANTIES EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW SHALL HAVE NO GREATER DURATION THAN THE WARRANTY PERIOD SET FORTH ABOVE. UNDER NO CIRCUMSTANCES SHALL CLARION CORPORATION BE LIABLE FOR ANY LOSS OR DAMAGE, DIRECT OR CONSEQUENTIAL, ARISING OUT OF THE USE OR INABILITY i TO USE OF THE PRODUCT. BECAUSE SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS OR EXCLUSIONS OR LIMITATIONS OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, THE ABOVE LIMITATIONS OR EXCLUSIONS MAY NOT APPLY TO YOU. [. . . ] If the system has been programmed for Passive Mode, the Starter Kill will automatically activate 30 seconds after the ignition has been turned off. After the ignition has been turned off, the status LED will flash rapidly to indicate that the system is in Passive Mode. If Passive Mode has been programmed on, then it is also possible to program the system for Passive Locking. With Passive Locking, the vehicle doors lock automatically at the same time that the Starter Kill is activated. If Passive Locking is programmed on, care must be taken to prevent the keys from being locked in the vehicle. note: For Passive Mode to be effective, the Starter Kill relay must be installed. 6 unlocking/disarming Pressing for one second disarms the system and unlocks the doors (if connected). The horn will honk twice (if connected) and the parking lights will flash twice to confirm disarming of the system. The status LED will turn off, unless the system is programmed for Passive Mode. In Passive Mode, the status LED will flash rapidly when the system is disarmed. This indicates that the system will re-engage the starter kill and re-lock the doors (if Passive Locking has been programmed) in 30 seconds unless the ignition is turned on. note: If the system has been armed with the remote, you must use the remote or the Override switch to disarm the system and deactivate the starter kill. Manually unlocking the vehicle does not disarm the system; it will only unlock the doors. 7 disabling the system without a remote If your remote is lost or damaged, you can manually override the system. To do this, you must have the vehicle's ignition key and know where the Override switch is located. Be sure to check with the installer for the location of the Override switch. If the vehicle does not start, you may have waited too long; turn the ignition off and repeat the process. Location of Override Switch _________________________________ DRW-35 silent arm/disarm To temporarily turn off the arm or disarm chirps, use Silent Arm/Disarm. Simply press for less than one second before arming or disarming, and the confirmation chirp(s) will be eliminated for that one operation only. If you want the arm/disarm chirps turned off permanently, your dealer can do this for you. 8 override mode You can prevent your system from automatically activating the Starter Kill and locking the doors by using override mode. In override mode, the starter kill cannot be activated, even with the remote, but all convenience functions (door locks, trunk release, etc. ) will continue to work normally. To enter or exit override mode: 1. Press and then release the DRW-35 Override switch within 10 seconds. The status LED will light steadily if you are entering override mode and will turn off if you are exiting override mode. panic mode If you are threatened in or near your vehicle, you can attract attention by triggering the system with your remote. In panic mode, the horn will honk and the parking lights will flash for 30 seconds. To stop panic mode at any time, press on the remote again. note: In order for panic mode to be effective, the vehicle's horn (or optional siren) as well as the vehicle's parking lights must be connected. 9 individual recognition Individual recognition is a feature available. Using the Pro Security Programmer, a hand-held programming tool, your dealer can program many of the system settings. [. . . ] The first system provides control that will roll up two windows automatically when the system is armed, or roll two windows down by using the remote. Progressive Door Unlocking: For added security, your system can be configured to unlock the driver's door only, leaving the passenger doors locked. Pressing the unlock button an additional time will unlock the passenger doors. This option requires additional parts and labor. 13 14 Cut along dotted line and fold for a quick and easy reference to keep in your purse or wallet. Press and hold QUICK REFERENCE GUIDE To lock/arm using your remote To arm the system press for one second. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE CLARION K10




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual CLARION K10 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.