User manual CLARION MAP360

[. . . ] Copyright The information contained herein may be changed at any time without prior notification. This manual nor any parts thereof may not be reproduced for any purpose whatsoever without the express written consent of Clarion, nor transmitted in any form either electronically or mechanically, including photocopying and recording. This manual offers the following search facilities: In the footnote at the bottom of the page, you may check which chapter and which section you are actually reading. A glossary at the end of the manual contains explanations on the technical terms used in this manual. [. . . ] For information on saving your home address, please refer to "Home address", page 93. Destinations may be stored in two lists: the FAVOURITES the RECENT DESTINATIONS list Every destination you are indicating and the destinations from the RECENT DESTINATIONS list may be added to the FAVOURITES. This makes sense if you want to navigate more often to the respective destination. You have entered a destination as described in "Indicating a destination", page 35 - OR ­ You have opened the RECENT DESTINATIONS list as described in "Recent destinations", page 49. You have opened the FAVOURITES as described in "Favourites", page 47 - OR ­ You have opened the RECENT DESTINATIONS list as described in "Recent destinations", page 49. Indicating several destinations (Itinerary with stages) This function is only available in "Extended mode". Indicating several destinations (Itinerary with stages) Repeat steps 2-4 for every stage point you want to add to the itinerary. At any moment, you may add stage points, modify the order of the stages, or display the itinerary on the map. The following commands are available on the ITINERARY PLANNING screen: These icons are deactivated when the list does not contain any route point. Tap this icon several times to move the selection several route points up. Tap this icon several times to move the selection several route points down. Route point up Tap this icon to navigate to the respective stage point earlier (example: stage 3 becomes stage 2). Tap this icon to navigate to the respective stage point later (example: stage 2 becomes stage 3). Delete route point Tap this icon to delete the selected route point from the list. The new stage point will be added before the stage point which currently has the focus. Indicating several destinations (Itinerary with stages) Save itinerary Only itineraries that contain at least one route point may be saved. Load itinerary This icon is deactivated if there is no saved itinerary available. (This icon is deactivated if there is no saved itinerary available) The SELECT ITINERARY screen opens: Enter the new name of the itinerary. Indicating several destinations (Itinerary with stages) (This icon is deactivated if there is no saved itinerary available) The SELECT ITINERARY screen opens: An itinerary may be calculated even without GPS reception in order to get an impression on the route. The system assumes then the first route point to be the start point of the route. Note: When you start navigation, the system identifies your current position and makes it the start point. Indicating several destinations (Itinerary with stages) Tap this icon to calculate the distance and the estimated duration of the entire itinerary. [. . . ] This is necessary for the system to indicate correct times of arrival in navigation mode. Element Time zone Daylight saving time Signification Tap this entry field to select the time zone of the region you are currently staying in. Tap this entry field to switch between daylight saving time (yes) and standard time (no). Note: If there is a clock change or if you are travelling into another time zone, you will have to adjust the respective setting. [. . . ]