User manual CLARION SR1000

[. . . ] Model SR1000 O Owner's Guide limited lifetime consumer warranty This Ungo Pro Security system is warranted against defects in material and workmanship. This Limited Lifetime Warranty applies to Ungo Pro Security systems that have been installed by an authorized Ungo Pro Security dealer. This warranty is to the Original Purchaser ("Owner") and to the original vehicle in which it was installed into. This warranty is not transferable to any subsequent owner(s) of the product(s). [. . . ] Before turning off the engine, press and release twice within 3 seconds on the remote (or press and release the optional momentary switch). (The engine will stay running. ) The engine will run until the pre-programmed time elapses or a shut-down input is received. (See the previous remote engine start section for a complete list of shut-down inputs. ) 2. 3. note: This feature will not work if the brake pedal is being pressed. 18 short-run/turbo Short run turbo mode keeps the engine running after arriving at you destination for a programmable period of 1, 3, 5 or 10 minutes. This allows the system's timer to conveniently cool down the turbo after you have left the vehicle. and buttons at the same The lights will flash to indicate the remote engine start has entered short run turbo mode. The engine will turn off after the programmed run time. timer mode By pressing the remote and buttons the parking lights will flash 4 times and then start the vehicle and run for the set duration. The remote engine start can be shut off by the remote by pressing the remote start button and remain in timer mode, but if any other shut down zones or the ignition becomes active the timer mode will cancel. The system will start the car and will run for the specified duration, unless shut down by the remote start button . 19 . If shut down with the remote start button will remain in timer mode. 5. the system The system will start every 3 hours until canceled by the brake, hood, or neutral safety shut-down wires. important!Never start and run the vehicle in an enclosed space such as a garage or carport. To exit timer mode, turn the ignition switch on any time the engine is running. The parking lights will flash 4 times, indicating timer mode has been exited. safety features This system has several important safety features to ensure proper operation of the motor and prevent accidental damage to the engine or its components. starter anti-grind circuitry Whenever the vehicle is remote started, advanced anti-grind circuitry prevents the starter from engaging, even if the key is turned to the start position. This prevents damage to the starter motor if the key is turned to the start position during remote engine start operation. 20 disabling the remote engine start system This feature allows your system's remote engine start unit to be temporarily disabled to prevent the vehicle from being remote started accidentally. This feature is useful if the vehicle is being serviced or stored in an enclosed area. To disable the remote engine start, move the shutdown toggle switch to the OFF position. Location of Shutdown Switch ____________________________ over and under rev protection The system monitors the engine speed and will automatically shut the engine off if the RPMs rise above or fall below the programmed levels. This feature prevents damage to the motor due to fuel delivery system failures or other problems which may cause the engine to race. note: The system uses a wire connected to the vehicle to sense engine speed. This wire must be connected in order for over and under rev protection to work. shut down inputs This security system uses several inputs to shut down the remote start operation of the motor or prevent remote engine start if certain inputs are active. The hood input will prevent the motor from starting, as well as shut it down, any time the hood is opened. The brake pedal will shut down the motor at any time during remote engine start operation, as well as preventing the remote engine start from activating while it is being pressed. . 21 false alarm prevention circuitry Your system has false alarm prevention circuitry. It prevents annoying repetitive trigger sequences due to faulty door pin switches or environmental conditions such as thunder, jackhammers, airport noise, etc. [. . . ] The first system provides control that will roll up two windows automatically when the system is armed, or roll two windows down by using the remote. This second system also provides one touch switch operation. 32 glossary of terms Control Unit: The "brain" of your system. The control unit houses the microprocessor which monitors your vehicle and controls all system functions. Fault-Proof Starter Interrupt: An automatic switch controlled by your system that prevents the vehicle's starter from cranking whenever the system is armed. [. . . ]