User manual CLARION VMA6491

[. . . ] Doing so may cause damage and void the warranty. · Be careful not to run down the car's battery while using a multimedia system with the engine stopped. Doing so may damage the vehicle's battery or the multimedia system. · Do not disassemble or modify the monitor. Doing so may damage it and void the warranty. · Keep moisture away from the set. Water and humidity may damage the internal circuitry. · Do not let the monitor become overheated. [. . . ] Use sandpaper to remove any paint from the surface where the ground terminal is attached. DESCRIPTION OF PICTURE ADJUSTMENT INSTALLATION: MOUNTING HOLE LOCATIONS: Your Clarion VMA6491 monitor, has four (4) additional side threaded mounting holes. Now the VMA6491 is useable with all Clarion's mounting bracket methods (PQE023, ZMT009). The VMA6491 accommodates the ZMT009 gooseneck mount when a bottom mounting screw location is necessary. The VMA6491 3 VMA6491 6. 4" TFT LCD Monitor monitor will accept a video signal from any video source with composite video output. The Infrared (IR) sensor will work directly with a Clarion TTX001 or VDH9600 using the IR extension cable provided (see Application starting on page 5 for details). 1. Make sure the monitor will not interfere with the driver's safe operation of the vehicle. Once a location has been determined, run the 3. 5 mm IR extension, Video RCA and Power molex connector into the monitor's mounting location. Mount the monitor using four (4) M4x8 mm machine screws (machine screws are provided with the mounting brackets). Run the IR extension, video, and power cables to their respective destinations. When using the VDH9600 and TTX001 together, make all of your connections near the VDH9600 (see the figure on page 5 for more details). INSTALLATION 4 OWNER'S MANUAL APPLICATIONS: (With the VDH9600, TTX001 and the FM100S) 1. Mount the TV antenna (ZCB-303 or equivalent) and plug it into the TTX001 antenna input connector. Plug the 16-pin A/V Output and 2-pin Power Molex connector into the TTX001 tuner. Using the supplied A/V cable, connect the Left (white), Right (red), and Video (yellow) RCAs into their corresponding LINE IN locations on the back of the VDH9600. Connect the IR extension cable from the TTX001 into one of the jack inputs on the 3. 5 mm mono Y-connector (not provided). Connect the plug side of the Y-connector to the REMOTE SENSOR INPUT on the back of the video play- 5 APPLICATIONS VMA6491 6. 4" TFT LCD Monitor er. Connect the other jack end of the Y-connector into the IR extension cable coming from the VMA6491 monitor. Plug the video RCA from the VMA6491 into the LINE OUT video connection on the rear of the player. Plug the provided audio RCA cable into the L/R LINE OUT audio connections. Connect the power wires from the VMA6491, TTX001, and the power wires of the VDH9600 together. Run both the audio RCAs and power wires to the radio location and plug the audio RCAs into the FM100S audio inputs. Mount the switch for the FM100S and run its' power wire to the radio location. [. . . ] Pick a location to mount the WH100/200 transmitter, plug in the L/R audio RCAs and power connector. Connect all the power wires together and run to a fused accessory wire in the vehicle. APPLICATIONS OPERATION: (With TTX001 and WH100/WH200) 1. Since the IR signals from each of the components are linked together, point the RC-300 remote control at the SENSOR located on the front of the VMA6491. Press POWER on the RC-300 remote control to turn the TTX001 TV tuner ON. [. . . ]