User manual CONCORD TRANSFORMER X

[. . . ] · Only if safety equipment is correctly installed and used can your child enjoy maximum safety. · The system straps must be fitted tautly and without twists and must be protected against damage. · Protect those parts of the CONCORD TRANSFORMER that are not covered in fabric from direct sunlight to avoid your child being burned. [. . . ] It can only effectuate its maximum safety properties if it is used properly. The cover is an important component and contributes to the seat's effectiveness; for this reason the seat must only be used with its original cover!You should therefore ensure that you follow the instructions for fitting and use carefully. The seat may be used on any seat in your car that is fitted with a three-point seat belt. Statistics suggest that the place behind the passenger seat is the safest in the car. _INSTALLINGTHECONCORDTRANSFORMER Place the CONCORD TRANSFORMER on the car seat or bench seat, facing in the direction of travel. In cars with standard headrests, these may be adjusted or removed to make it easier to install the child car seat. Please note that the car headrests must be replaced and re-positioned correctly when an adult is travelling in the car. The seat may not be transported unsecured in the vehicle, even if there is no child passenger. Otherwise passengers risk injury during the journey or in the event of an accident. For this reason, the belt must always be fastened when travelling. 28 29 _SECURINGTHECHILDwITHTHETHREE-POINTBELT Seat your child well back in the seating area. Pass the three-point belt across the front of the child to the seat belt lock, and fasten it in the same way as for an adult. Pass the lap belt across both sides and the diagonal belt on the side of the seat belt lock through the lap belt guide (03). Finally, pass the diagonal belt through the provided shoulder belt guide (07). To adjust the CONCORD TRANSFORMER to the size of the child, gently press the head section (01) down. Now press the size adjustment button (05) on the back of the backrest and keep it pressed whilst moving the head section (01) into the required position. The CONCORD TRANSFORMER can be continuously adjusted to the right size and is locked into the current position when the adjustment button (05) is released. Make sure the belt passes inside the securing hook. The shoulder belt guide (07) should be slightly above the top of the child`s shoulder. At the same time, the shoulder belt should pass centrally between the child`s neck and the outer edge of the shoulder. [. . . ] At the manufacturer's discretion, the guarantee shall cover rectification, replacement or a price reduction. In the event of any defect, claims can not be considered unless the specialist dealer is notified of the fault as soon as it occurs for the first time. If the specialist dealer is unable to remedy the problem himself, he must return the product to the manufacturers together with details of the complaint, official proof of purchase and the purchase date. [. . . ]