User manual CURTIS CR1252

[. . . ] Wall or Ceiling Mounting - The appliance should not be mounted to a wall or ceiling. Ventilation - The appliance should be situated so that its location or position does not interfere with its proper ventilation. For example, the appliance should not be situated on a bed, sofa, rug or similar surface that may block the ventilation openings, or placed in a built-in installation, such as a bookcase or cabinet, that may impede the flow of air through the ventilation openings. 6. 9. Heat - The appliance should be situated away from heat sources such as radiators, heat registers, stoves, or other appliances (including amplifiers) that produce heat. . [. . . ] Adjust only those controls that are covered by the operating instructions as an improper adjustment of other controls may interfere with the product's normal operation. f) When the product exhibits a distinct change in performance-this indicates a need for service. Servicing - The user should not attempt to service the product beyond that described in the operating instruction. Power Lines - An outside antenna system should not be located in the vicinity of overhead power lines, or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching power lines or circuits as contact with them might be fatal. Outdoor Antenna Grounding - If an outside antenna is connected to the receiver, be sure the antenna system is grounded so as to provide some protection against voltage surges and built up static. Section 810 of the National Electrical Code ANSI/NEFA 70 provides information with respect to proper grounding of the mast and supporting structure, grounding conductress, location of antenna-discharge unit, size of grounding electrodes, and requirements for the grounding electrode (see figure). Lightning - For added protection for this product during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the product due to lightning and power-line surges. Safety Check - Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operation condition. Overloading - Do not overload wall outlets, extension cords, or integral convenience receptacles as this can result in a risk of fir or electric shock. 4 NEC NATIONAL ELECTRICAL CODE Do not apply oil or petroleum products to this product. CAUTION Invisible laser radiation will be emitted when the product is open and interlocks are defeated. GRAPHIC SYMBOLS WITH SUPPLEMENTARY MARKINGS ARE LOCATED ON THE BOTTOM OF THE UNIT. USE OF CONTROLS, ADJUSTMENTS, OR PERFORMANCE PROCEDURE HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE. 5 LOCATION OF CONTROLS 1. ALARM/RADIO SELECTOR (ALARM / RADIO) HOUR SET BUTTON (HOUR) AUTO/ OFF /ON SWITCH (AUTO / OFF / ON) MINUTE SET BUTTON (MIN) 7. Set the radio volume by rotating the Volume Dial clockwise to the desired volume level. To turn off the radio, slide the AUTO/OFF/ON Switch to the "OFF" or "AUTO" (if the alarm is set) position. Reference the "Setting the Alarm" procedures if resetting the alarm function. Note: For better reception, FM wire antenna shall be fully untied and adjusted well. This unit has a built-in antenna for AM and FM, Locate the unit where you can obtain the best reception. Setting the Time To set the hour(s): Press and hold the "TIME. SET" Button, then press the "HOUR" Set Button until the correct hour(s) is reached. [. . . ] Press the Sleep Set button, the radio will turn on automatically and will turn itself off when the present time has passed. The radio will be switch off automatically when the sleep time expires. To turn the radio off before the expiration of sleeping time, simply press the "SNOOZE" button. BATTERY BACK-UP Your clock has a battery back up feature in case of power failure. [. . . ]