User manual CURTIS FRW120

[. . . ] USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE. To prevent direct exposure to the laser beam, do not try to open the enclosure. Refer to the identification/rating label located on the back panel of your product for its proper operating voltage. Caution: Using video games or any external accessory with fixed images for extended periods of time can cause them to be permanently imprinted on the picture tube (or projection TV picture tubes). [. . . ] (3) Adjust the volume of your receiver to a comfortable listening level to avoid any speaker damage. COAXIAL To PCM/BITSTREAM Coaxial cable (Optional) To digital audio input Connection Example Amplifier equipped with digital audio input Front speaker (left) Front speaker (right) COAXIAL To PCM/BITSTREAM (Optional) 10 Instruction ManualManual FUNCTIONS & FEATURES Turn On/Off 1. Turn On Plug in the power cord, and the TV should enter into Standby mode. Pressing STANDBY key will turn on the TV and its power indicator light. Standby (Soft Off) While the TV is on, press the STANDBY key will put the TV in Standby or off mode. The power indicator light on the TV set will turn off. Basic Functions Changing the Channel While in Tuner mode, press the CH+/- keys to change the channel, or use the numeric keypad to enter a new channel. Also, you may press the FUNCTION (F) key along with the VOL +/ - keys to adjust the volume in increments or decrements of 4. To restore the volume, press MUTE again or press the VOL + key. Function Selection Menus To change the setting of any function, press the MENU key to bring up the main menu. Press to highlight the desire sub-menu and press (or ENTER) to access. While in the sub-menu, press to select the item and to adjust the setting. While in the setup menu, CH-/+ and VOL-/+ key on the front panel will function as the / / on the remote control. Picture Menu Features This menu allows you to adjust the various picture settings. Tint: -31 (more purplish) to +31 (more greenish) Brightness: 0 (dimmest) to 63 (brightest) Contrast: 0 (minimum contrast) to 63 (maximum contrast) Color: 0 (minimum color) to 63 (maximum color) Sharpness: 0 (minimum sharpness) to 63 (maximum sharpness) Note: To control picture artifacts reduce the sharpness setting when viewing DVD discs. Picture Tint Brightness Contrast Color Sharpness 00 32 32 32 32 11 Instruction Manual FUNCTIONS & FEATURES (continued) Tuner Menu Note: This menu is only accessible while the TV is in Tuner mode. Pressing the MENU key with a rating highlighted will block that particular rating from being shown on this TV. Please note that blocking a lower rating (for example, PG) will block all higher ratings (PG-13, R, NC-17, X. ) Movie G PG PG-13 R NC-17 X Rating U U U U U U Age Based Rating Pass Code Menu This menu allows you to change the access code for the Parental Guide functions of the TV set. Press to highlight Pass Code, then enter the new Pass Code using the numeric keypad. Note: Pass Code Menu Pass Code Control Pass Code 6688 The factory pre-set password is 6688. Please contact the service centre in case you forget the password. Enter Pass Code - - - - 13 Instruction ManualManual FUNCTIONS & FEATURES (continued) Useful Remote Control Features DISPLAY This key allows you to display the current information of the TV screen on the upper right hand corner of the screen. (channel, antenna mode, time, video, etc. ) SCAN Press the SCAN key twice, and the TV will begin to scan through all active channels. PICTURE Your TV has factory preset picture modes that allow you to optimize your TV viewing. To activate these picture modes, press this key, and you can choose among User, Normal, Movie and Sports. RECALL This key will allow you to return to the last channel you were viewing. CC Pressing the CC key will activate the currently selected Closed Caption or Text under the System Menu. VIDEO This key allows you to toggle between antenna and different video modes. [. . . ] (2) If different instructions appear on the TV screen, follow those instructions. The instructions above are describing the basic procedure where the procedures may vary depending on the contents of the DVD video disc. Locating a specific chapter or track This unit allows you to locate consecutive chapters or tracks. Press the PREV or NEXT key repeatedly to display the requested chapter or track. [. . . ]