User manual CURTIS RCD641

[. . . ] Accessories ­ Do not place this product on an unstable cart, stand, tripod, bracket, or table. The product may fall, causing serious injury to a child or adult, and serious damage to the product. Use only with a cart, stand, tripod bracket, or table recommended by the manufacturer, or sold with the product. Any mounting of the product should follow the manufacturer's instructions, and should use a mounting accessory recommended by the manufacturer. [. . . ] Overloading ­ Do not overload wall outlets, extension cords, or integral convenience receptacles as this can result in a risk of fire or electric shock. Object and Liquid Entry ­ Never push objects of any kind into this product through openings as they may touch dangerous voltage points or short-out parts that could result in fire or electric shock. Servicing ­ Do not attempt to service this product yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Damage Requiring Service ­ Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions: ¡D Reorient or relocate the receiving antenna. ¡D Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ¡D Consult the dealer or an experienced radio/TV technician for help. Operation is subject to the following two conditions: (1) (2) This device may not cause harmful interference, and This device must accept any interference received, including interference that may cause undesired operation. -4- -5- WARNING Read the instruction manual before you attempt to use the unit. Consult your dealer or service personnel if you have questions about the installation, operation or safety of the unit. Using higher voltage outlets could cause the unit to malfunction or catch fire. Make sure all electrical connections (including extensions and inter connectors) are properly made. Do not place unit near heaters or in areas subjected to direct sunlight. Do not place unit near TVs, speakers and other objects that generate strong magnetic fields. Do not operate unit if it is not working normally or has been damaged in any way. Turn unit off, unplug it from the power source and consult service personnel. BAND Button 23 15 7 8 9 10 11 12 13 14 16 SETTING UP AND CONNECTING THE STEREO SYSTEM Antenna connection FM: Install the FM Antenna wire connecting plate to FM Antenna Terminal (19) and tighten it with a screwdriver. If stereo broadcast received, the STEREO indicator will be displayed on the display (1) This unit is equipped with a built-in directional ferrite antenna, move and rotate the unit for best reception. AM: 17 18 23 19 20 21 22 24 Speaker connection To insert the speaker cables by pushing down the terminal lever of Left Speaker Terminal (21) and Right Speaker Terminal (22). Please ensure the cables are connected into the speaker terminals with the correct polarities. Connect the left speaker to the terminals L and the right speaker to the terminals R. LINE IN (AUX IN) connection Grey 25 26 27 28 29 30 31 32 33 34 45 48 35 36 37 38 39 40 41 42 43 44 1. Connect one end of a RCA plug signal wire (not included) to Aux Input Socket (18) and the other end of wire to your home equipment. Press LINE IN (29) on the remote control while display indicates "LINE". Connect one end of a RCA plug signal wire (not included) to Subwoofer Socket (17) and the other end of wire to your subwoofer. [. . . ] Use a sharp tip to press into the reset hole to reset the built-in microcomputer. CARE AND MAINTENANCE l l l l l l l Treat the disc carefully. Never allow your fingers to contact with the shiny, unprinted side of the disc. If disc skips or gets stuck on a section of the disc, it is probably dirty or damaged (scratched). When cleaning the disc, wipe in straight lines from the center of the disc to the edge of the disc. [. . . ]