User manual CURTIS RT110

[. . . ] HOW TO REPLACE LIGHT BULB FOR TORCH SPECIFICATION : Light bulb 3V/500mA A. Don't drop any metal parts inside when you lift up the lamp cover. Power Source Selector Power 2. Use the cursor buttons on the unit or remote control to navigate the DVD menu. [. . . ] Do not mix alkaline or standard (carbon zinc) with rechargeable (nickel cadmium) batteries. To prevent damage, do not allow moisture to enter the battery compartment. If the unit will not be used for an extended period of time, make sure the unit is unplugged from the AC power supply and/or remove the batteries. Replace the batteries with fresh ones or use an alternate source of power. The DC plug from the car cord or the AC adaptor must be removed from the DC socket to operate the receiver using battery power. Dry battery operating time and efficiency decreases at low temperatures (usually below +41'F/5' C). Always turn off the unit and ' Mosquito Repeller ' to save battery life. Connect the DC plug coming out of the AC adaptor (included with this set) into the DC 12V socket in the receiver and then plug the AC adaptor into the wall outlet. Do not overcharge as this will shorten the service life of the Ni-Cad batteries. Before use, be sure that the Ni-Cad batteries have been fully charged. AC adaptor Car Battery Operation Using the Car Cord Plug one end of the DC car cord into the DC 12V Power Input Jack of the receiver and the other end into the cigarette lighter of your vehicle. CAUTION: Do not plug the AC cord directly into the unit as this is dangerous and will burn the unit. The AC cord should always plug into the AC adapter with the other end DC 12V jack into the unit (See diagram) WRONG CORRECT NOTE : This receiver is designed to operate on 12V DC. Power Source Selector must be set to 'EXT. ' position. DC car cord (12V DC) Neg. To DC socket Ground Only the Cigarette Lighter Socket of Car Unserew the cap to replace the fuse. (replace only with same type fuse 3A 125/250V) Fuse 3A, Screw cap Replacing Fuse CAUTION: 1. Remove plug from cigarette lighter receptacle when the receiver is not in use 2. To prevent electrical shock and possible damage to your unit or vehicle, always unplug the car cord from the cigarette lighter socket BEFORE you remove the plug from the DC 12V Jack of the receiver. Be sure negative and positive terminals are positioned as indicated in battery compartment. Slide Power Source Selector to the position 'BATT'. DC 12V Jack P. 8 P. 9 CONTROLS AND FUNCTION ANTENNA / POWER SUPPLY Telescopoic Rod Antenna 31. [. . . ] This will prevent damage to the receiver due to lightning and power-line surges. An outside antenna system should not be located near overhead power lines or other electric lights or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal. [. . . ]