User manual CURTIS SCR2608

[. . . ] Cleaning-The appliance should be cleaned only as recommended by the manufacturer. Nonuse Periods-The power cords of the appliance should be unplugged from the outlet when unused for an extended period of time Object and Liquid entry-Care should be taken so that objects do not fall and liquids are not spilled into the housing. Damage Requiring Service-The appliance should be serviced by qualified service personnel when: · The Power-supply cord or the plug has been damaged; or · Object have fallen or liquid has been spilled into the appliance; or · The appliance has been exposed to rain ; or · The appliance does not appear to operate normally or exhibits a marked changed in performance ;or · The appliance has been dropped or the housing damaged. Servicing-The user should not attempt to service the appliance beyond that described in the operating instructions. [. . . ] c) Tape fold-down portion to backside of overhand, tape template to cabinet underside. Note: If your cabinet has glue blocks or other obstructions, cut out corresponding areas on the template to clear them. CAUTION: It is recommended that safety glasses be worn while drilling screw holes to prevent the possibility of eye injury. Step 2 Drill 1/4" inches diameter holes through the underside of the cabinet bottom shelf using the three points marked on the template. Helpful Hints: On wooden cabinets you may want to mark and start the drill holes with a nail or an awl. Be sure to hold the drill very firmly against the cabinet to reduce "walking" of the drill bit from the markings. Using masking tape above the hole locations on inside of wooden cabinet shelf to help reduce splintering. If installing the unit under a wood cabinet, you may wish to countersink the drilled hold for the INSIDE of the cabinet if a countersink the holes use the supplied washers. Step 3 Remove template and clean drill shavings from inside and underside of cabinet. Select the spacer or combination of spacers that is equal to or longer than the cabinet overhang. Step 5. The washers must be used on metal cabinets, and on wood cabinets if you did not countersink the drilled holes. Hold screw heads down while you push the selected spacers onto the screws under the cabinet. Be sure to push up spacers until they fully nested (if more then one is in used) Step 7 Align radio under the screws. Hold the screw holes in the top of the clock radio against the mounting screws and partially tighten the screws. 10:27pm -> 9:27am) 4. Press MEMORY/C-ADJ button, enter to minute adjustment mode. ( Minute will begin to flash) d . 9:27am -> 9:20am) e) and then press MEMORY/C-ADJ button, finish clock adjustment. NOTE: For 12 Hour display, If the time is pm, then PM icon will appear. And " AM" will not indicate on the display Time setting is invalid if the time always flashes. ALARM TIME SETTING 1. While in the CD or Radio mode, Press "Display/AL. Set" one time to enter the alarm time set mode. Press and hold MEMORY/C- ADJ button for 2 seconds, enter to alarm hour adjustment mode (Alarm hour will begin to flash) 3. 10:27pm -> 9:27am) Press MEMORY/C-ADJ button, enter to alarm minute adjustment mode. ( Alarm minute will begin to flash) Press SKIP >>| or SKIP |<< button to desired time. 9:27am -> 9:20am) and then press MEMORY/C-ADJ button, finish clock adjustment. After setting the alarm time. Press AL. SET KEY (on the remote controller) repeatedly to select Buzzer mode. Press Power/AL. Off button to turn off the alarm when it sounds. TO WAKE UP TO CD: a. [. . . ] REPEAT PLAY To Repeat Single Track Press REPEAT/MEM/RCL button while the track you want to repeat is playing. ------To repeat another track, Press SKIP >>| button or SKIP |<< button. To Repeat all the tracks Press REPEAT/MEM/RCL button twice during play. ------All tracks will be played through in sequence and then the sequence will be repeated continuously. [. . . ]