User manual CURTIS SRCD3050

[. . . ] ACCESSORIES Do not place this product on an unstable cart, stand, tripod, bracket, or table. the product may fall, causing serious injury and serious damage to the product. Use only with a cart, stand, tripod, bracket, or table recommended by the manufacturer or sold withe the product. any mounting of the product should follow PORTABLE CART WARNING the manufacturer's instructions, and should use a (symbol provided by RETAC) mounting accessory recommended by the manufacturer. [. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/ TV technician for help. ELECTRIC SERVICE EQUIPMENT GROUNDING CONDUCTORS (NEC SECTION 810-21) GROUND CLAMPS POWER SERVICE GROUND ELECTRODE SYSTEM (NEC ART 250, PART H) NEC-NATIONAL ELECTRICAL CODE S2898A EXAMPLE OF ANTENNA GROUNDING AS PER ANTIONAL ELECTRICAL CODE 18. SERVICING Do not attempt to service this product yourself as opening or removing covers may expose you to dangerous voltage or other hazards. REPLACEMENT PARTS When replacement parts are required, be sure the service technician uses replacement parts specified by the manufacturer or those that have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock or other hazards. SAFETY CHECK Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition. WALL OR CEILING MOUNTING The product should be mounted to a wall or ceiling only as recommended by the manufacturer. DAMAGE REQUIRING SERVICE Unplug the product from the wall outlet and refer servicing to qualified service personnel under the following conditions: a. If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions, as an adjustment o other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation. When the product exhibits a distinct change in performance - this indicates a need for service. HEAT The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat. NOTE TO CATV SYSTEM INSTALLER This reminder is provided to call the CATV system installer's attention to article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical. NONUSE PERIODS The power cord of the appliance should be unplugged from the outlet when left unused for a long period of time. DANGER: Invisible and hazardous laser radiation when open and interlock failed or defeated. Avoid direct exposure to beam. FCC WARNING: This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made. LASER SAFETY: This unit employs a laser. Only qualified service personnel should attempt to service this device due to possible eye injury. CAUTION: USE OF CONTROLS, ADJUSTMENTS OR PERFORMANCE PROCEDURE HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE. B PRECAUTIONS 1 2 3 Read the Operating Instructions carefully and completely before operating the unit. [. . . ] COPYRIGHT Please check the copyright laws relating to recordings from disc, radio or external tape for the country in which the machine is being used. I SPECIFICATIONS NOTE Do not use irregular shape CDs(example: heart-shaped, octagonal ones). Tuner section Frequency range: FM : 88-108 MHz AM : 530-1700 KHz General Speaker: 77 mm cone type (2) Output: Headphones jack (stereo jack) Power output: 1. 0 W +1. 0 W Power requirements: DC 12 V using eight size C batteries, AC 120V, 60Hz Weight: 2. 4Kg (excluding batteries) Dimensions: 290(W)x160(H)x250(D) mm Accessory: AC cord (1) Deck section Track format: Frequency range: Recording system: Erasing system: Heads: 4 track, 2 channels Normal tape DC bias Magnet erase Recording / playback head Erasure head F TUNER OPERATION 1 Set function to RADIO. For better reception - Extend the FM antenna and orient it for the best reception; AM antenna is inside the unit. Position the unit for the best reception. CD player section Disc: Scanning method: FM ST: Reception is stereo. [. . . ]