User manual CURTIS STC580

[. . . ] OWNER'S MANUAL 58 GHz 58 GHz In Use Low Batt. Cordless Phone PA GE RED IAL PAU SE VO L CH MUT E FLA SH MEM O TAL K ABC DEF 1 GHI 2 JKL 3 MNO 4 PRS 5 TUV 6 WXY 7 8 OPER 9 * 0 # chg / in use 5. 8 GHz Cordless Telephone PLEASE READ BEFORE OPERATING THIS EQUIPMENT Model : STC580 Contents Safety Instructions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Base unit Controls. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Getting Started. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Cordless Telephone Operation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] When you have finished your call, either press the TALK button or place the HANDSET on the BASE UNIT. The HANDSET IN USE LED indicator will turn off and the BASE UNIT IN USE/CHARGE LED will light up to indicate that the HANDSET is charging. VOL NOTES: 1. During a telephone conversation, press the VOL (VOLUME) button to select the desired HANDSET receiver volume level from MAXIMUM, HIGH, MEDIUM, or LOW. Press the (+) button to increase, or press the (-) button to decrease the volume level. A double "beep" sound will be heard when the (+) or (-) button is pressed further after the MAXIMUM or the LOW volume level. The BASE UNIT does not have a ringer and does not ring when receiving an incoming call. If you are too far away from the BASE UNIT, the HANDSET emits "beep" sounds to warn you that the background noise level is too high for proper communication between the HANDSET and the BASE UNIT. When you hear this sound, you should move closer to the BASE UNIT to reduce the noise level. Otherwise, the call will automatically cut off. 9 Cordless Telephone Operation Receiving Calls with the HANDSET on the BASE UNIT 1. NOTE: The HANDSET RINGER ON/OFF switch must be in the "ON" position for ringer to operate. To end your conversation, either press the TALK button or place the HANDSET on the BASE UNIT. If you place the HANDSET on the BASE UNIT CHARGE CRADLE, you activate the automatic STANDBY feature. CH VOL MUTE MEMO FLASH TALK 3 Receiving Calls with the HANDSET off the BASE UNIT 1. To end your conversation, either press the TALK button or place the HANDSET on the BASE UNIT. If you place the HANDSET on the BASE UNIT CHARGE CRADLE, you activate the automatic STANDBY feature. Storing Numbers 1. Be sure the BASE UNIT IN USE LED indicator is off and the HANDSET is in STANDBY mode. Dial the TELEPHONE KEYPAD 0~9 button where you want to store that number. Repeat steps 1 through 5 to store other telephone numbers. VOL 10 Cordless Telephone Operation EXAMPLE : To store the number 115-1968 under the TELEPHONE KEYPAD 1 button: 1 - Press the MEMO button. IMPORTANT: The maximum number of digits that can be stored for any phone number is 16 in PULSE or TONE mode. The maximum number of digits for mixed (TONE and PULSE in combination) dialing is 15. If you are using a switchboard system to access an outside line (such as an 8 or 9), press the PAUSE button to store a PAUSE. 5 - You have stored 115-1968 under TELEPHONE KEYPAD 1 button. Recalling Stored Numbers from Memory 1. EXAMPLE: To recall number 115-1968 stored under the TELEPHONE KEYPAD 1 button: 1 - Press the TALK button. [. . . ] In most areas, but not all, the sum of the RENs for all devices connected to one line should not exceed five (5. 0). To be certain of the number of devices that you may connect to your line, you should contact your local telephone company. If your telephone causes harm to the telephone network, the telephone company may temporarily disconnect your service. If possible, they will notify you in advance that temporary discontinuance of service may be required. [. . . ]