User manual CURTIS TID5030

[. . . ] Run the AC power cord through the provided cable channel for flush desk mounting. Tip: If your telephone outlet is not modular, contact your telephone company for assistance. Wall mounting the telephone. The unit may be wall mounted either on a telephone wall plate or with two screws (not included). If using screws, insert them into the wall leaving 3/16'' of each screw extending out from the wall. [. . . ] When you have finished your call, place the handset back in the base to hang up. Review the incoming call messages (up to 80 sets) Press Review Left Up [ ] Key or Review Right Down[ ] Key repeatedly to review the last sets of incoming call message. (such as phone number, date and time of the call) Review the outgoing call messages (9-30 sets) Press OUT Key repeatedly to review last 9-30 sets of outgoing call messages (such as the phone number) Flash When accessing telephone services, such as call waiting, use the [FLASH] key rather than the hook switch to access the other call. The [Flash] key automatically sends the correct signal and duration, no matter how long the key is pressed. New Call indicator When new caller ID information has been received. The new call indicator will being to flashing. SPEED DIAL OPERATION Storing speed dial 1. While continuously holding down the hook switch or when the telephone line cord is disconnected 2. Dial the number you wish to dial (the display can be show up to 12 digits) using the digital keys or review the incoming or outgoing number. And then press digital<0-9 key> to store the number in the location which you desire to store in. Note: there is a time-out for storing numbers, if the times out before the number is stored, try again please. Press the [AUTO] key, and then press the digital key (1-0) where the number was stored. If the unit times out before the number is stored, try again. CALLER ID When you are subscribed to caller ID service and a call is received, the unit will display the caller information sent by the telephone company . including: telephone number (if available), and the date and the time of the call. Calls are put in sequence and numbered to indicate their place in the sequence. When more than 80 calls have been received, the oldest messages are replaced with the new call information. When you receive more than one call from the same telephone number, the display will show REP in the upper right corner to indicate it is a repeat call. Only the most recent repeat call is recorded, and REP indication goes away after the record has been viewed. TO DELETE CALL(S) FROM MEMORY For Incoming Call(s): 1. Press (OUT) & the (DELETE) buttons twice within 2 seconds to delete. Note: In on-hook mode, Press<DELETE> to delete the pre-dialed numbers one-by-one. In off-hook mode, Press<DELETE> to start calling timer. IMPORTANT: All messages will be deleted when battery is removed. . RADIO OPERATION INSTRUCTION AM/FM band selector . . . Slide this selector to either AM or FM to select the desired radio band. [. . . ] Check Hook Switch: Does it fully lift from Base when Handset is removed?You may have pulse service, slide Tone/Pulse Switch to PULSE 2. You cannot be 1. Is Handset Coiled Cord Inserted properly and securely? heard by the other party. Line out of order, check phone in another room's jack or in your neighbor's home 4. Phone does not ring 5. Incoming outgoing and voice 1. [. . . ]