User manual CURTIS TID876

[. . . ] For products intended to operate from battery power, or other sources, refer to the operation instructions. 8. Grounding Polarization - This product may be equipped with a polarized alternating current line plug (a plug having one blade wider than the other). This plug will fit into the power outlet only one way this is a safety feature. If you are unable to insert the plug fully into the outlet, try reversing the plug. [. . . ] Power-Cord Protection - Power supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the appliance. Nonuse periods - The power cord of the appliance should be unplugged from the outlet when left when left unused for a long period of time. Object and Liquid Entry - Care should be taken so that objects do not fall and liquids are not spilled into the product case through product openings. Damage Requiring Service - Unplug this product from the wall outlet and take it to qualified service personnel under the following conditions. b) If liquid has been spilled into, or objects have fallen into the product. d) If the product does not operate when used according to the operating instructions. Adjust only those controls that are covered by the operating instructions as an improper adjustment of other controls may interfere with the product's normal operation. f) When the product exhibits a distinct change in performance-this indicates a need for service. Servicing - The user should not attempt to service the product beyond that described in the operating instruction. Power Lines - An outside antenna system should not be located in the vicinity of overhead power lines, or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching power lines or circuits as contact with them might be fatal. 18. A glowing dot appears in the lower left hand corner of the display, indicating that the time shown is PM time. TO SET THE ALARM Step 1 Press the Alarm set button to check the alarm time. Step 2 Press the Alarm set button together with the HOUR or MINUTE button to adjust the alarm time, paying close attention on the PM indicator. NOTE: A glowing dot appears in the lower left hand corner of the display indicating that the alarm has been set to operate. TO PLAY THE RADIO Step 1 Slide the AUTO/OFF/ON switch to the "ON" position. Step 2 Turn the radio on and select the desired radio station and volume setting as previously instructed. Your units is now set to turn on automatically at the pre-selected alarm time. TO WAKE TO BUZZER Step 1 Follow step 1 to step 3 under "TO WAKE TO RADIO". Step 2 Rotate the VOLUME/BUZZER switch to the "BUZZER" position. You will be awakened at the pre-selected alarm time by the buzzer tone. To turn the Buzzer off, slide the AUTO/OFF/ON switch to the "OFF" position or press ALARM SET/OFF Button. ALARM OFF Slide the AUTO/OFF/ON switch to "OFF" position if you wish to turn off the radio or buzzer after the radio or buzzer has sounded in the Wake to Radio or Wake to Buzzer operation. [. . . ] The alarm will not sound again until the next day unless you switch back to "AUTO" position or use alarm button to shut off alarm, then the radio or buzzer will automatically sound again in 24 hours at the same alarm setting. SLEEP CONTROL Step 1 Turn the AUTO/OFF/ON switch on the "AUTO" or "OFF" position. If you wish the radio to play for a shorter period simply press the SLEEP button together with the MINUTE button to set the desired time period, or if you wish to play longer, press SLEEP button along with HOUR button top play for 1 hour and 59 minutes (MAX). The radio will turn on automatically and will turn itself off when the pre-set time has passed. [. . . ]