User manual CURTIS TID889

[. . . ] Never touch the lens If you hear no sound when playing a disc, DO NOT turn the volume up high because the music could suddenly begin at high volume. To avoid hurting your ears or damaging the speakers, turn the volume control to the lowest level before starting playback and slowly turn it up to the desired level Note on listening with the headphones Listen at moderate volumes to avoid hearing damage Do not wear the headphones while driving or cycling. lt may create a traffic hazard You should use extreme caution or temporarily discontinue use in potentially hazardous situations, such as walking, jogging, etc Invisible laser radiation when open and interlocks defeated. [. . . ] Avoid exposure to beam. CAUTION Listening to headphone stereo at full power for extended periods of time can result in hearing damage Do not touch pickup lens Note on condensation lf the unit is suddenly moved from a cold place to a warm one, it may cause in condensation on the pickup lens and malfunction or playback difficulties, should this occur, leave the unit for a few hours, then try playback again. PRECAUTIONS To maintain good performance Do not use the unit in places which are extremely hot, cold, dusty or humid, In particular, do not use or keep the unit in following places. in a high humidity area such as a bathroom near a heater in an area exposed to direct sunlight (e. g. , inside a parked car, where it can become extremely hot) near sources of strong magnetism, such as televisions, speakers, or magnets where there is a lot of movement or vibration, such as on a car dashboard or an unstable shelf USING ON DRY CELL BATTERIES A Open the battery compartment and insert two LR6 (size AA) alkaline batteries with the and marks correctly aligned. Battery replacement The battery indicator in the display according to the remaining power of the batteries. Replace the batteries when lights. If the unit remains in use after lights. If the cover of the battery compartment comes off B Note on dry cell batteries Do not mix the different types of batteries, or an old battery with a new one To prevent the risk of electrolyte leakage or explosions, never recharge the batteries, apply heat to them, or take them apart, must set recharge button to "OFF". When not using the batteries, remove them to pre vent needless battery wear If liquid leaks from the batteries, wipe thoroughly to remove USING ON RECHARGEABLE BATTERIES C Be sure to use size AA Ni-Cd 1. 2V rechargeable batteries. which are commercially available . Be sure to read the instructions of the purchased rechargeable batteries before use Before charging the batteries, close the disc compartment, you cannot charge the batteries while it is opened Only for the special rechargeable batteries which expose part on the polarity. To search for the beginning of a track: Press or To locate a desired passage: Keep or Pressed. Release the button until the start of desired passage. REPEAT ONE: " 1"light on display and will repeat the track you selected REPEAT ALL: " ALL" light on display and will repeat entire tracks At stop mode, press until "INTRO" lights on display and will play the first 10 seconds of each track SHUFF: "SHUFF" light on display Plays every tracks in random order ANTI SHOCK: light on display until Press again then change to normal play No Disc: if no disc then "No Disc" is displayed. At STOP mode, Press PROGRAM key, Then "PROG 00"start flashing. When desired track is display, press PROGRAM key to register, Then track No. Registered tracks can be check by press PROGRAM key, And it can be changed by repeat 2-3. Open the door or power off to clean programing 3 CONNECTION TO AN EXTERNAL UNIT I Use a commercially available connection cord which has a 3. 5mm stereo plug at one end and two phono plugs at the other end. Connect the stereo plug to the LINE OUT jack of the unit and connect the phono plugs to the analog input (AUX) terminals of the external unit. [. . . ] Open the door or power off to clean programing 3 CONNECTION TO AN EXTERNAL UNIT I Use a commercially available connection cord which has a 3. 5mm stereo plug at one end and two phono plugs at the other end. Connect the stereo plug to the LINE OUT jack of the unit and connect the phono plugs to the analog input (AUX) terminals of the external unit. Volume and bass boost on this unit have no effect on the line output. MAINTENANCE To clean the lens J If the lens become dirty, the player will skip or not play, If this occurs, clean the lens in the following. [. . . ]